User manual ASUS GIGAX 1024I PLUS

[. . . ] In no event shall ASUS, its directors, officers, employees, or agents be liable for any indirect, special, incidental, or consequential damages (including damages for loss of profits, loss of business, loss of use or data, interruption of business and the like), even if ASUS has been advised of the possibility of such damages arising from any defect or error in this manual or product. Specifications and information contained in this manual are furnished for informational use only, and are subject to change at any time without notice, and should not be construed as a commitment by ASUS. ASUS assumes no responsibility or liability for any errors or inaccuracies that may appear in this manual, including the products and software described in it. Products and corporate names appearing in this manual may or may not be registered trademarks or copyrights of their respective companies, and are used only for identification or explanation and to the owners' benefit, without intent to infringe. GigaX Series L2 Managed Switch User Guide Federal Communications Commission Statement This device complies with Part 15 of the FCC Rules. [. . . ] Then you will see the newly added entry shown in the address window. Users can select one port from Port Selection, then click on You will see the current total secure MAC addresses of the port shown in the address window. Users can remove the existed address by selecting the entries with the to remove them. When you want to mouse, then click on select multi-entries, please press 'Shift' key on the keyboard and selecting the entries with the mouse. or to make the configuration effective Figure 54. Secure MAC Address GigaX Series L2 Managed Switch User's Guide 4. 9 QoS When you configure the QoS feature, you can select specific network traffic to prioritize it according to its importance. It makes the network performance more predictable and the bandwidth utilization more effective. QoS pages include trust state, mapping, class set, policy set, policy attach, and CoS function. 4. 9. 1 Trust State This page is used to configure packets classification using port trust states. Users can configure the port in following field: · Port: select the port to make configuration. Three types of state are supported for each port. a) No No trust state to classify ingress packets b) CoS Classifies ingress packets with the packet CoS values. A class set is a mechanism that you use to isolate a specific traffic flow (or class) from all other traffic. The class set defines the criteria (match mode) used to match a specific traffic flow to further classify it. The criteria can include matching ACL rule in a Filter Set ID or DSCP list. Only one match mode and only one ACL rule for each class set are supported. After a packet is matched against the class-map criteria, it will be further classified through corresponding policy set. The following fields are available: · Class Name: input a class name. · Filter Set ID: if the match mode is `Filter', users must select an existed filter set ID. · DSCP: if the match mode is `DSCP', users must input DSCP values. after you create a new class by the above information. Click on Then you will see the new added entry shows in the class list. Click on to select the class that you want to modify. [. . . ] TCP is responsible for dividing data up into packets for delivery and reassembling them at the destination, while IP is responsible for delivering the packets from source to destination. When TCP and IP are bundled with higher-level applications such as HTTP, FTP, Telnet, etc. , TCP/IP refers to this whole suite of protocols. Telnet/SSH An interactive, character-based program used to access a remote computer. While HTTP (the web protocol) and FTP only allow you to download files from a remote computer, Telnet / SSH allows you to log into and use a computer from a remote location. [. . . ]