User manual ASUS GIGAX 2024B

[. . . ] GigaX2024B Layer 2 Managed Switch User Manual E2403 December 2005 V1 Copyright © 2005 ASUSTeK COMPUTER INC. No part of this manual, including the products and software described in it, may be reproduced, transmitted, transcribed, stored in a retrieval system, or translated into any language in any form or by any means, except documentation kept by the purchaser for backup purposes, without the express written permission of ASUSTeK COMPUTER INC. Product warranty or service will not be extended if: (1) the product is repaired, modified or altered, unless such repair, modification of alteration is authorized in writing by ASUS; or (2) the serial number of the product is defaced or missing. ASUS provides this manual "as is" without warranty of any kind, either express or implied, including but not limited to the implied warranties or conditions of merchantability or fitness for a particular purpose. [. . . ] The User-based Security Model (USM), which provides authentication, encryption, and decryption of SNMPv3 packets. The View-based Access Control Model (VACM), which provides access control. Click to save the configuration permanently or to refresh the page. 4. 6. 4. 1 VACM view VACM View is used to view the information of SNMPV3 VACM Group. View Name: enter the security group name. View Type: enter the View Type that the View belongs. Included or Excluded when View Subtree matches the Oid in the SNMPv3 message. View Subtree: enter the View Subtree that the View belongs. The Subtree is the Oid to match the Oid in the SNMPv3 message. The match is good when the subtree is shorter than the Oid in the SNMPv3 message. Click on the Add when you create a new VACM View entry by the above information. Then you will see the new added entry shows in the view window. You can remove the existed views by selecting the entry with the mouse, then clicking on Remove. The Modify button updates the existed VACM View entries. Click Reload to refresh the settings to current value. To make the configuration effective, please go to "Save Configuration" page, then click on Save. Figure 40. SNMPv3 VGU Table 1 38 GigaX2024B L2 Managed Switch User Manual 4. 6. 4. 2 VACM group VACM Group is used to configure the information of SNMPV3 VACM Group. Group Name: enter the security group name. Read View Name: enter the Read View Name that the Group belongs. The related SNMP messages are Get, GetNext, GetBulk. Write View Name: enter the Write View Name that the Group belongs. Notify View Name: enter the Notify View Name that the Group belongs. The related SNMP messages are Trap, Report. . [. . . ] TCP is responsible for dividing data up into packets for delivery and reassembling them at the destination, while IP is responsible for delivering the packets from source to destination. When TCP and IP are bundled with higher-level applications such as HTTP, FTP, Telnet, etc. , TCP/IP refers to this whole suite of protocols. Telnet/SSH An interactive, character-based program used to access a remote computer. While HTTP (the web protocol) and FTP only allow you to download files from a remote computer, Telnet / SSH allows you to log into and use a computer from a remote location. [. . . ]