User manual ASUS GIGAX 2024SX

[. . . ] The pair is open (the cable is not attached to any device). Blinking The port failed to execute VCT. Off VCT is in progress (PORT SELECT LED is blinking). OR No error is found (PORT SELECT LED is green). [. . . ] Blinking The port failed to execute VCT. Off VCT is in progress (PORT SELECT LED is blinking). OR No error is found (PORT SELECT LED is green). 1 ­ 16 STATUS Green (Port Select) SPEED (Pairs 1, 3) Green Amber DUPLEX (Pairs 2, 4) Green Amber On On NOTE. The number of lighted LEDs on Pairs 1 ~ 4 shows the distance from the switch to the defective point (1 LED = 10 meters). Table 4 Buttons BUTTON VCT SEL Function Start, execute, or exit VCT Select the port to execute VCT ASUS GigaX 1116 5 English Table 3 LED indications in VCT mode Rear Panel English Power connector Fans Connecting network devices To connect network devices to the switch: 1. Connect one end of an Ethernet cable to an Ethernet port on the front panel of the switch. Connect the other end to the Ethernet port of the network device. Repeat this step to connect other network devices. NOTES · · Use only Category 5 Ethernet cables to ensure proper connections between the switch and other network devices. You may use the ports on the switch to uplink to another switch, hub, bridge, or repeater as an uplink port using either crossover or straight-through cables. The MDI/MDIX feature of the switch allows automatic detection of the type of cables connected to it, and adjustment to the appropriate MDI or MDIX setting for each cable. 2. Plug one end of the power cable to the power connector on the switch rear panel, then plug the other end to an electrical outlet. The Power LED and the LED indicators for active Ethernet ports light up to indicate that the device is on and in use. Align a mounting bracket with the screw holes on one side of the switch. Secure the mounting bracket using three screws. Follow steps 2 and 3 to secure the other bracket. Place the switch on a 19-inch rack, then secure it with two rack mount screws. NOTE. The rack mount screws are not included in your switch package. Use the screws from the rack. ASUS GigaX 1116 Troubleshooting This troubleshooting guide provides answers to some common problems that you may encounter while installing and/or using the switch. These problems require some simple troubleshooting that you can perform by yourself. Contact ASUS Technical Support if you encounter problems that are not mentioned in this section. Problem The POWER LED does not light up. Action Check if the power cable is properly connected to the switch, and to an electrical outlet with the correct voltage output. · Check if the Ethernet cable is properly connected to the switch and to the network device. [. . . ] · Check if the Ethernet cable is properly connected to the switch and to the network device. · Make sure that the switch and your network device are turned on. · Check if the Ethernet cable is sufficient for your network speed. Make sure you are using at least Category 5 cables for 100/1000 Mbps. [. . . ]