User manual ASUS GIGAX 2024X

[. . . ] · · · · Switch (GigaX1105 or GigaX1108) AC adapter This installation guide Wall mount screws NOTE. Contact your retailer if any of the items are damaged or missing. ASUS GigaX1105/GigaX1108 Front panel English 1-3 The GigaX1105 and GigaX1108 differ only in the number of Ethernet ports. The LED indicators function the same on both models. GigaX1105 GigaX1108 Front Panel Table Label/LED POWER 1 ­ 5 (GigaX1105) 1 ­ 8 (GigaX1108) STATUS Color Green Status ON OFF Indication The switch is powered on. [. . . ] Each number identifies the port. (white text) (white text) Green ON Blinking OFF A link is established A link is established and data is being transmitted or received. 1000Mbps 100Mbps 10Mbps or no link is established. Switch is operating in full-duplex mode. Switch is operating in half-duplex mode and collisions are occurring. Switch is operating in half-duplex mode and no collisions are observed. SPEED Green Amber Amber ON ON OFF ON Blinking OFF DUPLEX ASUS GigaX1105/GigaX1108 Rear panel The GigaX1105 and GigaX1108 differ only in the number of Ethernet ports. English 1-4 GigaX1105 GigaX1108 Rear Panel Table Label/LED 1 ­ 5 (GigaX1105) 1 ­ 8 (GigaX1108) POWER Color Status Indication RJ-45 ports for connecting to other network devices RJ-45 ports for connecting to other network devices Connects to the supplied AC adapter. ASUS GigaX1105/GigaX1108 Connecting network devices 1. Connect one end of the Ethernet cable to the Ethernet port on the rear panel of the switch. Connect the other end to the Ethernet port on the other network device. Repeat this step for additional network devices. NOTES · Use Category 5 Ethernet cables, not exceeding 100 meters (328 feet), otherwise, there will be connection problems or a decrease in data transfer speeds. The Ethernet ports on the switch may be used as uplinks to other switches, hubs, bridges, or repeaters. Make sure that Category 5 cable is used. 10Mbit/sec connections may tolerate lower quality cables. · Try replacing your UTP Category 5 cable with a new one. The cable length between the switch and the network device must not exceed 100 meters (328 feet). · Some old network devices may have this problem and cannot be avoided. Make sure that the cable used are Category 5 certified. The STATUS LED does not light up after an Ethernet cable is attached. Collisions are occurring (DUPLEX LED blinking) and network performance is reduced. The speed indicator shows incorrect speed. ASUS GigaX1105/GigaX1108 1-7 English Glossary 10BASE-T 10 Mbps Ethernet over twisted pair cable (Category 3). 100 Mbps Ethernet over twisted pair cable (Category 5) 1000 Mbps Ethernet over twisted pair cable (Category 5) Allows network connections using either straight through or crossover cables. The most commonly installed computer network technology, usually using twisted pair wiring. Ethernet data rates are 10 Mbps, 100 Mbps and 1000 Mbps. [. . . ] Ethernet data rates are 10 Mbps, 100 Mbps and 1000 Mbps. Abbreviation for Megabits per second, or one million bits per second. Network data rates are often expressed in Mbps. [. . . ]