User manual ASUS M51SE EXPRESS GATE QUICK START GUIDE

[. . . ] Products and corporate names appearing in this manual may or may not be registered trademarks or copyrights of their respective companies, and are used only for identification or explanation and to the owners' benefit, without intent to infringe. · Intel, LANDesk, and Pentium are registered trademarks of Intel Corporation. · IBM and OS/2 are registered trademarks of International Business Machines. · Windows and MS-DOS are registered trademarks of Microsoft Corporation. [. . . ] To prevent electrical shock hazard, disconnect the power cable from the electrical outlet before relocating the system. CAUTION: This product is equipped with a three-wire power cable and plug for the user's safety. Use the power cable in conjunction with a properly grounded electrical outlet to avoid electrical shock. Components Electrical Safety Static-Sensitive Devices WARNING: Adapters, planars, diskette drives, and disk drives are sensitive to static electricity discharge. These devices are wrapped in antistatic bags to prevent this damage. Take the following precautions: · · · · · · If you have an antistatic wrist strap available, use it while handling the device. Do not remove the device from the antistatic bag until you are ready to install the device in the system unit. With the device still in its antistatic bag, touch it to a metal frame of the system. Avoid touching the solder joints or pins. If you need to lay the device down while it is out of the antistatic bag, lay it on the antistatic bag. Before picking it up again, touch the antistatic bag and the metal frame of the system unit at the same time. System Components Chassis Panels There are two panels on the chassis, one left side and one right side panel. Each panel is secured by two screws on the back of the server (as circled) and also by a CAM. The CAM has a rotating knob with its own keylock. Turn the knob counterclockwise to release and clockwise to secure. The keylock can be used to keep the knob from being turned by unauthorized people. WARNING: Always remove the power cord when working on the server internal components to prevent electrical shocks or damage to electrical components. ATX power supplies always have standby power even when powered Off when plugged into an AC electrical outlet. Left Side Panel II. Components Chassis Panels 14 Left Panel Knob Side Panel Screw Left side panel Fan Module Power Supply Housing Pentium II processors Ethernet Card SCSI RAID Card Graphics Card Server left side AM51SE Hardware Reference Guide II. System Components Circulation System The server's air circulation system is comprised of five 3 inch (8 cm) fans mounted on a metal fan module. The circulation system cools the hard disk drives by bringing fresh air in from the front and forcing the hot air out through the back. It is important to keep the air surrounding the hard disk drives below 122°F (50°C) to prevent hard disk failures. Fan Replacement II. [. . . ] Components SCSI Information 24 SCSI ID Jumpers All SCSI devices, including this motherboard with onboard SCSI, must have a SCSI identification number that is not in use by any other SCSI device. There are sixteen possible ID numbers, 0 through 15. The SCSI ID serves two purposes: · · It uniquely defines each SCSI device on the bus. It determines which device controls the bus when two or more devices try to use it at the same time. SCSI IDs on one channel do not interfere with the IDs on another channel. [. . . ]