User manual ASUS MY CINEMA-PS3-110

[. . . ] IN NO EVENT SHALL ASUS, ITS DIRECTORS, OFFICERS, EMPLOYEES OR AGENTS BE LIABLE FOR ANY INDIRECT, SPECIAL, INCIDENTAL, OR CONSEQUENTIAL DAMAGES (INCLUDING DAMAGES FOR LOSS OF PROFITS, LOSS OF BUSINESS, LOSS OF USE OR DATA, INTERRUPTION OF BUSINESS AND THE LIKE), EVEN IF ASUS HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES ARISING FROM ANY DEFECT OR ERROR IN THIS MANUAL OR PRODUCT. SPECIFICATIONS AND INFORMATION CONTAINED IN THIS MANUAL ARE FURNISHED FOR INFORMATIONAL USE ONLY, AND ARE SUBJECT TO CHANGE AT ANY TIME WITHOUT NOTICE, AND SHOULD NOT BE CONSTRUED AS A COMMITMENT BY ASUS. ASUS ASSUMES NO RESPONSIBILITY OR LIABILITY FOR ANY ERRORS OR INACCURACIES THAT MAY APPEAR IN THIS MANUAL, INCLUDING THE PRODUCTS AND SOFTWARE DESCRIBED IN IT. Products and corporate names appearing in this manual may or may not be registered trademarks or copyrights of their respective companies, and are used only for identification or explanation and to the owners' benefit, without intent to infringe. ii Contents Notices . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Doing so will damage the motherboard! 6. GAME/MIDI connector (16-1 pin GAME1) This connector is for a GAME/MIDI port. Connect the GAME/MIDI module cable to this connector, then install the module to a slot opening at the back of the system chassis. The GAME/MIDI port connects a joystick or game pad for playing games, and MIDI devices for playing or editing audio files. MY CINEMA-PS3-110 ® GAME MIDI_IN J2B2 J2CY MIDI_OUT J2CX J2B1 +5V MY CINEMA-PS3-110 Game connector ASUS MY CINEMA-PS3-110 +5V J1B2 J1CY GND GND J1CX J1B1 +5V USB+5V USB_P5USB_P5+ GND USB+7V USB_P7USB_P7+ GND 1 USB78 1 USB+8V USB_P8USB_P8+ GND NC 1-25 7. ATX power connector (20-pin ATXPWR1) This connector is for an ATX power supply. The plugs from the power supply are designed to fit these connectors in only one orientation. Find the proper orientation and push down firmly until the connectors completely fit. ATXPWR1 +12. 0VDC +5VSB PWR_OK COM +5. 0VDC COM +5. 0VDC COM +3. 3VDC +3. 3VDC +5. 0VDC +5. 0VDC -5. 0VDC COM COM COM PS_ON# COM -12. 0VDC +3. 3VDC ® MY CINEMA-PS3-110 ATX power connector 8. Internal audio connectors (4-pin CD, AUX) These connectors allow you to receive stereo audio input from sound sources such as a CD-ROM, TV tuner, or MPEG card. MY CINEMA-PS3-110 CD(Black) Right Audio Channel MY CINEMA-PS3-110 Ground Left Audio Channel AUX(White) ® Right Audio Channel Ground Left Audio Channel MY CINEMA-PS3-110 Internal audio connectors 1-26 Chapter 1: Product introduction 9. Front panel audio connector (10-1 pin FP_AUIDO1) This connector is for a chassis-mounted front panel audio I/O module that supports either AC `97 audio standard. Connect one end of the front panel audio I/O module cable to this connector. AGND +5VA BLINE_OUT_R ® FP_AUDIO1 MIC2 MICPWR Line out_R NC Line out_L MY CINEMA-PS3-110 Front panel audio connector 1 0 . Serial port connector (10-1 pin COM1) This connector is for a serial (COM) port. Connect the serial port module cable to this connector, then install the module to a slot opening at the back of the system chassis. The serial port bracket (COM1) is purchased separately. MY CINEMA-PS3-110 COM1 PIN 1 ® MY CINEMA-PS3-110 Serial port connector ASUS MY CINEMA-PS3-110 BLINE_OUT_L MY CINEMA-PS3-110 1-27 1 1 . Speaker out connector (4-pin SPEAKER1) This connector is for the case-mounted speaker and allows you to hear system beeps and warnings. MY CINEMA-PS3-110 SPEAKER1 ® MY CINEMA-PS3-110 Speaker connector 1 2 . Power LED connector (3-1 pin PWR_LED1) This 3-1 pin connector is for the system power LED. Connect the 3-pin power LED cable from the system chassis to this connector. Insert a formatted, high density 1. 44 MB floppy disk into the drive. Insert the Windows® 2000 CD to the optical drive. From the Open field, type D:\bootdisk\makeboot a: assuming that D: is your optical drive. Press <Enter>, then follow screen instructions to continue. Copy the original or the latest motherboard BIOS file to the bootable floppy disk. 2. 1. 2 AwardBIOS Flash Utility The Basic Input/Output System (BIOS) can be updated using the built-in Flash Memory Writer utility or using a bootable floppy disk with the executable Flash Memory Writer Utility (AWDFLASH. EXE). Follow these instructions to update the BIOS using this utility. Save only the updated BIOS file in the floppy disk to avoid loading a wrong BIOS file. The succeeding screens are for reference only. The actual displays may not exactly match what you see on your screen. Updating the BIOS file 1. Download the latest BIOS file from the ASUS website. Rename the file to *. BIN and save it to the bootable floppy disk you created earlier. Insert the disk that contains the new BIOS file into the floppy drive. 3. ASUS MY CINEMA-PS3-110 2-3 4. Press <Alt> + <F2> during POST to display the following screen. 5. [. . . ] Highlight the password field, and press <Enter> twice. The following message appears: "PASSWORD DISABLED!!!Press any key to return to the menu. A note about passwords The Supervisor password is required to enter the BIOS Setup program preventing unauthorized access. The User password is required to boot the system preventing unauthorized use. 2-34 Chapter 2: BIOS setup Forgot the password? If you forget your password, you can clear it by erasing the CMOS Real Time Clock (RTC) RAM. [. . . ]