User manual ASUS MYPAL A716

[. . . ] IN NO EVENT SHALL ASUS, ITS DIRECTORS, OFFICERS, EMPLOYEES OR AGENTS BE LIABLE FOR ANY INDIRECT, SPECIAL, INCIDENTAL, OR CONSEQUENTIAL DAMAGES (INCLUDING DAMAGES FOR LOSS OF PROFITS, LOSS OF BUSINESS, LOSS OF USE OR DATA, INTERRUPTION OF BUSINESS AND THE LIKE), EVEN IF ASUS HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES ARISING FROM ANY DEFECT OR ERROR IN THIS MANUAL OR PRODUCT. SPECIFICATIONS AND INFORMATION CONTAINED IN THIS MANUAL ARE FURNISHED FOR INFORMATIONAL USE ONLY, AND ARE SUBJECT TO CHANGE AT ANY TIME WITHOUT NOTICE, AND SHOULD NOT BE CONSTRUED AS A COMMITMENT BY ASUS. ASUS ASSUMES NO RESPONSIBILITY OR LIABILITY FOR ANY ERRORS OR INACCURACIES THAT MAY APPEAR IN THIS MANUAL, INCLUDING THE PRODUCTS AND SOFTWARE DESCRIBED IN IT. Microsoft, Activesync, Outlook, Pocket Outlook, Windows, and the Windows logo are either registered trademarks or trademarks of Microsoft Corporation in the United States and/or in other countries. [. . . ] Tap NOTE , then tap Programs. If you saved your backup file into an SD card or CF card, you need to insert that SD card or CF card into the SD/CF slot when restoring data. Otherwise, you will receive the message "No storage devices are found!" 2. On the ASUS Programs screen, tap the ASUS Backup icon. When prompted, stop all running programs. Tap the Restore tab on the ASUS Backup screen. In the Backup File screen: · select the backup file name (tap the arrow to list down other backup files, if any) · select the folder that contains your backup file (optional) · select the storage device (Flash Disk, SD card, or CF card) where you stored your backup file 6. When the restoration is done, a message appears prompting you to manually reset the device. Tap OK to reset. ASUS programs 4-39 Restoring PIM data To restore PIM data: 1. On the ASUS Backup screen, tap PIM Data. When prompted, select the storage device (Flash Disk, SD card, or CF card) where you stored your backup file. Tapping Cancel returns you to the previous screen. When the backup process is complete, the system automatically goes back to sleep (OFF). NOTE If no card is found, the device goes back to sleep without performing the backup process. When you turn on the device, either one of the following messages is flashed on the screen. The system detected a battery power low status. The system status was automatically backed up to ASUSBKUP. SAV file in the CF card (or SD card). If automatic backup is successful The system detected a battery power low status and tried to back up the system status at 2004/06/14, 10:21:27 AM. CF card (or SD card) not ready. If automatic backup failed because a CF card/SD card, is not ready in the slot The system detected a battery power low status and tried to back up the system status at 2004/06/14, 10:21:27 AM. Cannot access CF card (or SD card). If automatic backup failed because the CF card/SD card in the slot may be defective and not accessible 4-44 Chapter 4 The system detected a battery power low status and tried to back up the system status at 2004/06/14, 10:21:27 AM. Insufficient space in the CF card (or SD card). If automatic backup failed because the available space in the CF card/ SD card is not enough to back up the current system status The system detected a battery power low status and tried to back up the system status at 2004/06/14, 10:21:27 AM. System error. If automatic backup failed because a system error occurred ASUS programs 4-45 Manual backup To use manual backup: 1. Tap the System tab on the bottom of the Settings screen. Tap the SmartKeeper icon, then the Manual tab. Tap the Back up system button to back up the current system status to the CF card or SD card. If a CF card or an SD card is not present, an error message appears after you tap the back up button. NOTE While backing up, the screen blacks out and shows the message "Backup in progress" and the percentage of backed up data. A message appears to confirm that the backup process is complete. 4-46 Chapter 4 The screen displays the backup file information after the backup process. ASUS programs 4-47 Manual restore To restore the system status: 1. Tap the System tab on the bottom of the Settings screen. Tap the SmartKeeper icon, then the Manual tab. [. . . ] A-3 Notices A-1 Federal Communications Commission Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1) This device may not cause harmful interference, and 2) This device must accept any interference received, including interference that may cause undesired operation. This device and its antenna must not be co-located or operating in conjunction with any other antenna or transmitter. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. [. . . ]