User manual ASUS P-SERIES-P5945GQIG

[. . . ] E2799 P1-P5945G/P2-P5945G ASUS PC (Desktop Barebone) Installation Manual Download the latest manual from the ASUS website: www. asus. com Front panel features Close Optical drive eject button HDD LED Optical drive bay cover Press to open the front panel cover Power button Power LED Front panel features Open Reset button MS/MS Pro card slot Rear panel features Power connector Voltage selector* Center/LFE Surr-Rear Surr-Side Line In Line Out Rear MIC PS/2 mouse port PS/2 keyboard port LAN (RJ-45) port USB 2. 0 ports CompactFlash® card slot SD/MMC card slot 4-pin IEEE 1394 port USB 2. 0 ports Headphone port Microphone port SPDIF Out port VGA port DVI-D port Serial port PCI slot metal brackets * The system's power supply unit has a 115 V/230 V voltage selector switch located near the power connector. Use this switch to select the correct system input voltage according to the voltage supply in your area. 2 Installation manual Internal components 1 2 4 5 8 6 7 1. 4. 5. 25-inch optical drive and 3. 5 inch hard disk drive cage Front panel cover Power supply unit PCI card riser bracket (connected to the motherboard PCI slot) 5. [. . . ] Unlock the load lever, then lift to a 90º-100º angle. Lift the load plate, then remove the PnP cap. Retention tab Load lever 3. Install the CPU. The CPU fits in only one orientation. 4. Close the load plate, then lock the load lever. 5. Reinstall the CPU fan and heatsink assembly, then reconnect the CPU fan cable to the CPU fan connector on the motherboard. Refer to the instructions in the previous section for details. Installing a DIMM 1. Locate the DIMM sockets in the motherboard. Unlock a DIMM socket by pressing the retaining clips outward. Align a DIMM on the socket such that the notch on the DIMM matches the break on the socket. Installation manual 5 Installing an expansion card 1. Lift the PCI riser card assembly to remove. Remove the metal cover opposite the slot that you intend to use. 3. Insert the card connector to the slot, then press the card firmly until it fits in place. Secure the card with a screw. 4. Reinstall the PCI riser card assembly. Make sure that the riser card connector sits properly on the motherboard PCI slot. Installing optical and storage drives 1. Turn the storage drive assembly upside down with the 3. 5-inch bay on top of the 5. 25-inch bay. Insert the optical drive upside down to the 5. 25-inch bay, then secure it with two screws on both sides. Turn the storage drive assembly, insert the hard disk drive upside down to the 3. 5-inch bay, then secure it with two screws on both sides. 2 6 Installation manual Reinstalling the storage drive assembly Before reinstalling the storage drive assembly, connect the IDE/SATA and power plugs to the IDE/SATA and power connectors at the back of the drives. Connect the black plug of the IDE cable to the optical drive, then the gray plug to the hard disk drive. If you have the SATA HDD, connect the SATA cable to the SATA HD. [. . . ] Make sure the cover tabs fit the chassis rails. Push the cover toward the front panel until it fits in place. Secure the cover with two screws. 2 8 Installation manual [. . . ]