User manual ASUS P65UP5-P6ND

[. . . ] R P/I P65UP5 Baseboard for CPU Cards USER'S MANUAL USER'S NOTICE No part of this manual, including the products and softwares described in it, may be reproduced, transmitted, transcribed, stored in a retrieval system, or translated into any language in any form or by any means, except documentation kept by the purchaser for backup purposes, without the express written permission of ASUSTeK COMPUTER INC. ASUS PROVIDES THIS MANUAL "AS IS" WITHOUT WARRANTY OF ANY KIND, EITHER EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED TO THE IMPLIED WARRANTIES OR CONDITIONS OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL ASUS, ITS DIRECTORS, OFFICERS, EMPLOYEES OR AGENTS BE LIABLE FOR ANY INDIRECT, SPECIAL, INCIDENTAL, OR CONSEQUENTIAL DAMAGES (INCLUDING DAMAGES FOR LOSS OF PROFITS, LOSS OF BUSINESS, LOSS OF USE OR DATA, INTERRUPTION OF BUSINESS AND THE LIKE), EVEN IF ASUS HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES ARISING FROM ANY DEFECT OR ERROR IN THIS MANUAL OR PRODUCT. Products and corporate names appearing in this manual may or may not be registered trademarks or copyrights of their respective companies, and are used only for identification or explanation and to the owners' benefit, without intent to infringe. [. . . ] Depending on the height of the SIMM memory modules and the CPU fan and/or heatsink, the area above the SIMM memory modules may not be available. For both the C-P6ND and C-P55T2D CPU cards, be sure that your case has a minimum area clearance of 11 x 9. 25 x 5" (28. 5 x 23. 5 x 12. 7 cm), and for the C-PKND CPU card, 13. 5 x 9. 25 x 5" (34. 3 x 23. 5 x 12. 7 cm). 18 ASUS P/I-P65UP5 User's Manual 5" (12. 7 cm) 5" (12. 7 cm) III. INSTALLATION One end of the CPU card has a bracket, which should slide into the system case front panel. Be sure that the system case can support a long PCI card on the first slot and that a groove is available for the bracket. Refer to your respective CPU card's documentation for details. General Installation Procedures for the ASUS CPU Card: 1. Remove the CPU card from its packaging without touching the integrated circuit (IC) chips, connectors, and other components. Follow instructions in the CPU card manual on installing the processor/s, support bracket, and setting jumpers. Remove the expansion slot cover for the first slot. Carefully align the CPU card over the CPU Card Slot (CPU SLOT A and CPU SLOT B). Be sure that the card is perpendicular to the baseboard. Firmly press one end of the card halfway in, the other end halfway in, then the first end completely in, and finally, the second end completely in. Be sure that all the connectors are evenly inserted into the slots. Screw in the metal bracket to the system case. Move the system carefully and only with the power off because the CPU card is heavy as well as delicate. C-P55T2D C-P6ND C-PKND CPU Card Slot NOTE: The BIOS on the CPU cards are different. When adding a CPU card, find the BIOS chip that came with the CPU card and replace it with the one on the baseboard, if one is present. ASUS P/I-P65UP5 User's Manual 19 III. Expansion Cards First read your expansion card documentation on any hardware and software settings that may be required to set up your specific card. NOTE: PCI Slot 5 has a MediaBus extension, which allows the installation of either a PCI card or a MediaBus card (optional multifunctional card). Unplug your power supply when adding or removing expansion cards or other system components. Failure to do so may cause severe damage to both your baseboard and expansion cards. Expansion Card Installation Procedure 1. Read the documentation for your expansion card. Set any necessary jumpers on your expansion card. [. . . ] There are two settings, "terminated" and "not terminated, " as shown below. IV. ASUS SCSI Cards (Jumpers) 30 JP 5 JP 5 Terminated (Default) Not Terminated Terminator Setting (Terminated / Not Terminated) Decide whether or not you need to terminate the ASUS PCI-SC200 based on its position in the SCSI chain. Only the devices at each end of the chain need to be terminated. If you have only internal or only external devices connected to the ASUS PCI-SC200, then you must terminate the ASUS PCI-SC200. [. . . ]