User manual ASUS PRO66IC

[. . . ] (Asia-Pacific) Notices Safeguards Federal Communications Commission Statement This device complies with FCC Rules Part 15. Operation is subject to the following two conditions: · This device may not cause harmful interference, and · This device must accept any interference received including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. [. . . ] This class B digital apparatus complies with Canadian ICES-003. 4 Table of contents Disclaimer/Copyrights . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ASUS contact information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Notices . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Table of Contents . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . System package contents . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . About this guide . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 3 4 5 6 7 Chapter 1: System Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9 1. 1 1. 2 1. 3 Front panel features . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10 Rear panel features . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11 Internal features . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12 Chapter 2: System Assembly . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Optional connectors include: a 4 or 6 pin 1394 and a PCMCIA slot. Pull the door to open it. 10 Chapter 1: System Introduction 1. 2 Rear Panel Features The rear panel of the ASUS Prodigy Book Size Barebone System includes the standard PC99 I/O connectors for external devices, power supply socket, and optional feature connectors. The rear panel features: PS/2 Keyboard USB (0&1) Serial Port Parallel Port VGA Port Line Out Line In Microphone DVI-Out (optional) TV-Out (optional) Modem (optional) Game/MIDI PS/2 Mouse LAN Port Power Supply DVI-Out (optional) S/PDIF (optional) NOTE The rear panel optional features may vary as shown in the above pictures. ASUS Prodigy Book Size Barebone System 11 1. 3 Internal Features The figure below shows the system from above. The standard components are already installed. ASUS Motherboard CPU Cooler CD / DVD ROM Drive Power Supply PCI Riser Card 3. 5" Floppy Drive 12 Chapter 1: System Introduction Chapter 2 Step-by-step instructions on how to install basic components. IMPORTANT: ASUS has designed the Prodigy to accept an ASUS "Flex ATX" motherboard with dimensions between 19. 1 x 22. 9 cm, (or 7. 5 x 9 inches). It is not advisable to install other boards. Before installing any motherboard other than the original supplied by ASUS, make sure that it fits into the case and the I/O connectors correspond to the openings on the back panel. Prodigy Book Size Barebone System System Assembly 13 2. 1 Opening the chassis 1. Remove the two screws on each end of the back panel. This frees the the top cover from the chassis. 2. Seperate the case and top cover: use your thumbs to pull it off, from the front to the back, then lift it off the chassis. 3. Open the case, lifting the top cover. 14 Chapter 2: System Assemby 4. Lift the link-up bar to gain access to the components. 5. Gently detach the three front bezel hooks from the case front so that it may be removed. 6. Remove the front bezel and set it aside. Prodigy Book Size Barebone System 15 2. 2 Remove the disk drive assembly 1. Press your right thumb firmly down on the right edge of the chassis while gripping your fingers under both sides of the CD and floppy disk drive assembly. Firmly lift the assembly up and out. 2. Lift out the CD/floppy drive module. 3. Slide the hard disk drive cage from right to left and lift it up to install a hard disk. 16 Chapter 2: System Assemby 2. 3 Install the hard disk drive 1. Carefully slip the hard disk drive into the cage. [. . . ] Firmly insert the DIMM into the socket until the retaining clips snap back in place and the DIMM is properly seated. After installing the DIMM, place the CD and floppy drive assembly back into its original position. Then, replace the front bezel; take care to insert the three plastic tabs without stress. 4. CAUTION A DDR DIMM is keyed with a notch so that it fits in only one direction. DO NOT force a DIMM into a socket to avoid damaging the DIMM. 5. 6. 18 Chapter 2: System Assemby 2. 5 Install a CPU 1. [. . . ]