User manual ASUS PRO79ID

[. . . ] Using the Notebook PC Pointing Device 36 Using the Touchpad 36 Touchpad Usage Illustrations 37 Caring for the Touchpad 38 Automatic Touchpad Disabling 38 Storage Devices 39 Expansion Card 39 Optical Drive 40 Flash Memory Card Reader 42 Hard Disk Drive 43 Memory (RAM) 44 Connections 45 Modem Connection 45 Network Connection 46 Wireless LAN Connection (on selected models) 47 Windows Wireless Network Connection 48 Bluetooth Wireless Connection (on selected models) 49 Trusted Platform Module (TPM) (on selected models) 50 Fingerprint Registration (on selected models) 51 Antenna Connections (on selected models) 53 Appendix Optional Accessories Optional Connections Operating System and Software Glossary Declarations and Safety Statements Notebook PC Information 3 Contents 4 1. Introducing the Notebook PC About This User's Manual Notes For This Manual Safety Precautions Preparing your Notebook PC NOTE: Photos and icons in this manual are used for artistic purposes only and do not show what is actually used in the product itself. 1 About This User's Manual Introducing the Notebook PC You are reading the Notebook PC User's Manual. This User's Manual provides information on the various components in the Notebook PC and how to use them. The following are major sections of this User's Manuals: 1. [. . . ] Note:Makesurenottostabtheactivity indicatorlocatedinthesamearea. Using the Optical Drive Optical discs and equipment must be handled with care because of the precise mechanics involved. Keep in mind the important safety instructions from your CD suppliers. Unlike desktop optical drives, the Notebook PC uses a hub to hold the CD in place regardless of the angle. When inserting a CD, it is important that the CD be pressed onto the center hub or else the optical drive tray will scratch the CD. If the CD disc is not properly locked onto the center hub, the CD can be damaged when the tray is closed. Always watch the CD closely while closing the tray slowly to prevent damage. A CD drive letter should be present regardless of the presence of a CD disc in the drive. After the CD is properly inserted, data can be accessed just like with hard disk drives; except that nothing can be written to or changed on the CD. Using the proper software, a CD-RW drive or DVD+CD-RW drive can allow CD-RW discs to be used like a hard drive with writing, deleting, and editing capabilities. Vibration is normal for all high-speed optical drives due to unbalanced CDs or CD print. To decrease vibration, use the Notebook PC on an even surface and do not place labels on the CD. Listening to Audio CD The optical drives can play audio CDs, but only the DVD-ROM drive can play DVD audio. Connect one end to the modem port and the other end to an analog telephone wall socket (the ones found in residential buildings). Once the driver is setup, the modem is ready to use. NOTE: When you are connected to an online service, do not place the Notebook PC in suspend (or sleep mode) or else you will disconnect the modem connection. ExampleoftheNotebookPCconnectedtoatelephonejackforusewiththebuilt-inmodem: Telephone connector is the smaller of the two Telephone Wall Jack Telephone connection is optional Telephone cables with RJ-11 connectors CAUTION: For electrical safety concerns, only use telephone cables rated 2AWG or higher. (see Glossary for more information) 4 4 Using the Notebook PC Network Connection Connect a network cable, with RJ-45 connectors on each end, to the modem/network port on the Notebook PC and the other end to a hub or switch. For 100 BASE-TX / 1000 BASE-T speeds, your network cable must be category 5 or better (not category 3) with twisted-pair wiring. If you plan on running the interface at 100/1000Mbps, it must be connected to a 100 BASE-TX / 1000 BASE-T hub (not a BASE-T4 hub). For 10Base-T, use category 3, 4, or 5 twisted-pair wiring. 10/100 Mbps Full-Duplex is supported on this Notebook PC but requires connection to a network switching hub with "duplex" enabled. The software default is to use the fastest setting so no user-intervention is required. 1000BASE-T (or Gigabit) is only supported on selected models. Twisted-Pair Cable The cable used to connect the Ethernet card to a host (generally a Hub or Switch) is called a straight-through Twisted Pair Ethernet (TPE). [. . . ] Levér det brugte batteri tilbage til leverandøren. Explosionsfara vid felaktigt batteribyte. Använd samma batterityp eller en ekvivalent typ som rekommenderas av apparattillverkaren. Kassera använt batteri enligt fabrikantens instruktion. [. . . ]