User manual ASUS U RACK

[. . . ] A631 1U Rackmount Installation Guide English ® 1U Rackmount Kit Installation Guide Content English. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 19 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 27 2 English English 1U Rackmount Kit Installation Guide Rack Installation This installation guide provides a stepby-step procedure on how to install the AP1400R 1U Rackmount Server into a 4-post 19-inch industrial rack. Introduction Rackmount Kit Contents The AP1400R 1U Server Rackmount Kit includes the following items: 1. Screws Tool Required You will need one Phillips screwdriver to secure the rails and slides. IMPORTANT Before mounting the AP1400R 1U Rackmount Server, plan the server's location in the rack taking note of other rack components and ensuring effective cable management. [. . . ] Note that one end of a rail is straight and the other end is curved. Align a rail on one side of the chassis, matching the straight end with a mounting ear. Secure the rail with four screws opposite the outer holes on the spacers. Follow steps 1 and 2 to attach the other rail. Curved End Chassis Rail Straight End 6 English 3. Attach the Rack Slides Each rack slide includes an extension piece attached to it with a screw. You need to pull this extension so that the slide reaches the rear end of the rack. NOTE Racks vary in depth and require different length of slides. The extension was designed to serve this purpose. 3. 1 Secure the Front End 1. Select one unit of space (1U) on the rack where you desire to install the server. Align the holes on the bent end of a rack slide to the 1U space. Drive in two screws on the outer holes of the slide to secure it. Bent End with Three Screw Holes 4-Post 19" Rack 1U Rackmount Kit Installation Guide 7 3. 3. 2 Attach the Rack Slides Secure the Rear End 1. Find the 1U space on the rear of the rack that corresponds to the front 1U space where you attached the slide. Remove the screws from the rear 1U space. Remove the screw that secures the extension piece to the slide. Pull the extension to a length that fits the depth of the rack. Secure the extension to the rack slide with the screw that you removed in step 3. [. . . ] Attach the bottom edge of the faceplate to the hooks on the lower corners of the chassis. Swing the upper edge of the faceplate until the clips fit in place. NOTE When the server is settled on the rack, connect the cables to the rear ports. 10 English 11 Rack Installation 12 13 14 15 16 17 18 20 21 22 23 24 25 26 27 Rack Installation 28 29 30 31 32 33 34 MEMO R 35 ® www. asus. com 36 15-XXXXXXXXX [. . . ]