User manual ASUS U6E EXPRESS GATE QUICK START GUIDE

[. . . ] Remove the cover screws on the rear panel. Pull the side cover toward the rear panel until its hooks disengage from the chassis tabs. Locate the front panel assembly hooks, then lift them until they disengage from the chassis. [. . . ] Swing the front panel assembly to the right, until the hinge-like tabs on the right side of the assembly are exposed. Remove the front panel assembly, then set aside. 4 3 Air duct 1 2 1 4 3 4 2 3 Chassis tab holes 4 Installing a CPU To install a CPU: 1. Locate the CPU socket, then lift the socket lever to a 90º100º angel. 4 Quick installation guide 2. 3. Install the CPU to the socket, making sure that the CPU corner with the gold triangle matches the socket corner with a small triangle. Push down he socket lever to secure the CPU. Installing the CPU fan and heatsink assembly 1. Place the heatsink on top of the installed CPU, making sure that the heatsink fits properly on the retention module base. Attach one end of the retention bracket to the retention module base. Align the other end of the retention bracket (near the retention bracket lock) to the retention module base. A clicking sound denotes that the retention bracket is in place. Place the chassis upright, then remove the lower 3. 5" drive bay metal plate cover. Insert the floppy disk drive to the bay, then carefully push the drive until its screw holes align with the holes on the bay. Secure the floppy disk drive with two screws on both sides of the bay. Connect the signal (A) and power (B) plugs to connectors at the back of the drive. A 3 3 2 3. Place the chassis upright, then remove the upper 3. 5" drive bay metal plate cover. Insert the hard disk drive to the bay, then carefully push the drive until its screw holes align with the holes on the bay. Secure the hard disk drive with two screws on both sides of the bay. Quick installation guide 7 3 3 2 3. 4. For SATA HDD: Connect the SATA signal and power plugs to the connectors at the back of the drive. For IDE HDD: Connect the IDE signal and power plugs to the connectors at the back of the drive. SATA IDE Removing the bay covers and reinstalling the front panel assembly and side cover If you installed an optical and/or floppy disk drive, remove the bay cover(s) on the front panel assembly before reinstalling it to the chassis. Press the locks outward to release the bay cover. [. . . ] Press the locks outward to release the bay cover. Push the bay cover inward, then set it aside. Follow the same instructions to remove the 3. 5" drive bay cover. To reinstall the front panel assembly and side cover: 1. [. . . ]