User manual ASUS U6VC EXPRESS GATE QUICK START GUIDE

[. . . ] · Intel, LANDesk, and Pentium are registered trademarks of Intel Corporation. · IBM and OS/2 are registered trademarks of International Business Machines. · Symbios is a registered trademark of Symbios Logic Corporation. · Windows and MS-DOS are registered trademarks of Microsoft Corporation. [. . . ] Use the Flash Memory Writer utility to download the new BIOS file into the ROM chip as described in detail in this section. All computer motherboards provide a Setup utility program for specifying the system configuration and settings. If your motherboard came in a computer system, the proper configuration entries may have already been made. If so, invoke the Setup utility, as described later, and take note of the configuration settings for future reference; in particular, the hard disk specifications. If you are installing the motherboard, reconfiguring your system or you receive a Run Setup message, you will need to enter new setup information. This section describes how to configure your system using this utility. The BIOS ROM of the system stores the Setup utility. When you turn on the computer, the system provides you with the opportunity to run this program. This appears during the Power-On Self Test (POST). Press <Delete> to call up the Setup utility. If you are a little bit late pressing the mentioned key(s), POST will continue with its test routines, thus preventing you from calling up Setup. Valid values for hour, minute and second are: (Hour: (00 to 23), Minute: (00 to 59), Second: (00 to 59). If you do not want to modify the current time, press <Enter> three times to go to Hard Disks. NOTE: You can bypass the date and time prompts by creating an AUTOEXEC. BAT file. For information on how to create this file, refer to the MS-DOS manual. Hard Disk Drives This field records the specifications for all non-SCSI hard disk drives installed in your system. The onboard PCI IDE connectors provide Primary and Secondary channels for connecting up to four IDE hard disks or other IDE devices. Each channel can support up to two hard disks; the first of which is the "master" and the second is the "slave". Specifications for SCSI hard disks need not to be entered here since they operate using device drivers and are not supported by any the BIOS. If you install either the optional PCI-SC200 or PCI-SC860 SCSI controller card into the motherboard, see section VI for instructions. If you install other vendor's SCSI controller card, refer to their respective documentations on how to install the required SCSI drivers. For IDE hard disk drive setup, you can: · Use the Auto setting for detection during bootup. [. . . ] If you need more information before deciding on a certain option, you can always get help by pressing F1. Press <ENTER> to continue, <F1> for help, <F2> for README, or <F3> to exit. The following lines will be added to your system files: C:\AUTOEXEC. BAT file: SET CTCM=C:\CTCM C:\CTCM\CTCU /S /W=C:\WINDOWS C:\CONFIG. SYS file: DEVICE=C:\CTCM\CTCM. EXE Press <ENTER> to continue, <F1> for help, or <F3> to exit. Manager) 70 A message will appear on the next screen: Software installation completed. The following files were modified and its original saved with B~K extension. [. . . ]