User manual ASUS VH162S

[. . . ] Products and corporate names appearing in this documentation may or may not be registered trademarks or copyrights of their respective companies, and are used only for identification or explanation and to the owners' benefit, without intent to infringe. For documentation updates, visit the ASUS website at www. asus. com. tw. The specifications and information contained in this documentation are furnished for informational use only, and are subject to change at any time without notice, and should not be construed as a commitment by ASUS. ASUS assumes no responsibility or liability for any errors or inaccuracies that may appear in this documentation, including the products and the software described in it. [. . . ] Start your Windows 2000 system and log in. You must have Administrator privileges to install the driver software. When you boot up the Windows 2000 system after installing the adapter card, a series of Found New Hardware Wizard windows are displayed. In the Install Hardware Device Drivers window, click Search for a suitable driver for my device (recommended), then click Next. In the Locate Driver Files window, select the applicable search location check boxes, then click Next. When prompted, insert the media to be searched into your CD-ROM drive, type the path to the driver, and select OK. 18 ASUS VH162S User Guide Example: e:\ Where "e" is the designation of the CD-ROM drive on your system. In the Driver Files Search Results window, verify that the correct path to the driver software is shown, then click Next. If the Insert Disk screen appears, do not insert the Windows 2000 disk. Some early versions of Windows 2000 may display a spurious message prompting you to insert the Windows 2000 disk. If this occurs, leave the software and drivers CD-ROM in the drive and click OK. If asked to specify the location of the Windows 2000 CD-ROM instead, click Browse (do not use the text field) and locate the path to the ASUS VH162S PCI Express x1 Network Interface Card drivers. ASUS VH162S User Guide 19 W i n d o w s N T® Driver Software Installing the Driver Software · The ASUS VH162S PCI Express x1 Network Interface Card must be physically installed in your system prior to installing the driver software. See "Installing the Hardware" for details. If you are using the archive disk that you created, insert the disk into drive A: and press Enter. If you have the CD ROM mounted as a NetWare volume, press F3 and enter <Volume Name>: NetWware\Driver as the source path. Where <Volume Name> is the name of the NetWare Volume for the CD ROM and NetWare\Driver is the directory of the specific files on the CD ROM needed for this installation. Press Enter to select the highlighted driver. Select Yes and press Enter to copy the . LDI file. This is the installation script for the driver. Follow the instructions for the installation. Select Save parameters and load driver to continue. Choose Exit to return to the server console prompt. 7. 14. ASUS VH162S User Guide 27 If you are performing an initial installation of NetWare 4. 2/5. x/6. 0 and have more than two adapters installed, the install program will allow you to allocate the actual number of packet receive buffers needed by the adapter. During installation, the RxBuffers value should be set to 32, the minimum number of buffers the driver requires for each adapter. [. . . ] ifconfig bcme[instance_number] plumb ifconfig bcme[instance_number] ip_address netmask. . . . To make these changes permanent, follow these steps: 1. Use a text editor (e. g. , vi) and create a file named hostname. bcme[instance_number] in the /etc directory. Add the IP address of the interface to this file, then save and exit. Add a proper subnet mask to the file /etc/netmasks. 2. In Solaris 7. 0 (Intel platform), the operating system only allocates 36 pages of 4K physically contiguous memory. [. . . ]