User manual ASUS WL-330NUL

[. . . ] Launch your web browser and start surfing the Internet. mode 3 Plug WL-330NUL to a power source 1. Launch your browser and start surfing the Internet. To configure the router settings, please launch the WL-330NUL utility. [. . . ] Skriv inn passordet for det private nettverket. Indb 108 Su pe rvi so r co de : xx xxxx xx 12/29/12 1:32:19 PM Svenska • För Windows® användare Om din enhet använder Windows® operativsystem, se till att du har installerat WL-330NUL systemprogram innan du ansluter till Internet. Internetanslutning Välj ett av följande sätt för åtkomst till internet: Läge 1 Anslut Ethernet-kabeln till WL330NUL och koppla in i ett eluttag. Indb 111 12/29/12 1:32:50 PM Svenska • För Mac OS X användare Välj ett av följande sätt för åtkomst till internet: Läge 1 Anslut Ethernet-kabeln till WL330NUL och koppla in i ett eluttag. Internet Läge 2 Anslut WL-330NUL till en dator via en Ethernet-kabel Internet Följ stegen i To access the (att komma åt Internet via Ethernet (internet via Ethernet) i sektionen för användare av pekdatorer och smartphone. Läge 4 Anslut WL-330NUL till en dator Internet Följ stegen i To access the Internet wirelessly (Att komma åt internet trådlöst) i sektionen For tablet PC and smartphone users (för användare av pekdatorer och smartphone). Indb 122 12/29/12 1:34:04 PM Federal Communications Commission Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: • This device may not cause harmful interference. €  This device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. € Increase the separation between the equipment and receiver. €  Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. € Consult the dealer or an experienced radio/TV technician for help. Warning: Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. Prohibition of Co-locationThis device and its antenna(s) must not be co-located or operating in conjunction with any other antenna or transmitter. FCC Mark Warning This equipment must be installed and operated in accordance with provided instructions and the antenna(s) used for this transmitter must be installed to provide a separation distance of at least 20cm from all persons and must not be co-located or operated in conjunction with any other antennas or transmitters. End users and installers must be provided with antenna installation instructions and transmitter operating conditions for satisfying RF exposure compliance. Prohibition of Co-location IMPORTANT NOTE: This device and its antenna(s) must not be co-located or operating in conjunction with any other antenna or transmitter. [. . . ] Operation is subject to the following two conditions: • This device may not cause harmful interference. €  This device must accept any interference received, including interference that may cause undesired operation. IMPORTANT NOTE: Radiation Exposure Statement: This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment. End users must follow the specific operating instructions for satisfying RF exposure compliance. [. . . ]