User manual ASUS X71TL EXPRESS GATE QUICK START GUIDE

[. . . ] Products and corporate names appearing in this manual may or may not be registered trademarks or copyrights of their respective companies, and are used only for identification or explanation and to the owners' benefit, without intent to infringe. · QuickStart and JumperFree are trademarks of ASUSTeK Computer Inc. · Intel, LANDesk, and Pentium are registered trademarks of Intel Corporation. · IBM and OS/2 are registered trademarks of International Business Machines. [. . . ] These are not jumpers, do not place jumper caps over these pins. 1 X71TL X71TL 12-Volt Cooling Fan Power The following PANEL illustration is used for items 14-21 Keyboard Lock Message LED External SMI Lead Speaker Connector Ground Speaker Rotation +12V GND PWRBTN Ground IDELEDIDELED+ 1 X71TL ATX Power Reset SW Switch* HDLED Power LED * Requires an ATX power supply. X71TL System Panel Connectors 24 ASUS X71TL User's Manual PWRLED+ PWRLEDPWRLEDReset Ground MSGLED+ MSGLEDKeylock Ground ExtSMI# Ground +5V 3. H/W SETUP Connectors CPU Fan Power 3. HARDWARE SETUP 14) Message LED Lead (2-pin LED) This indicates whether the system is in normal mode or standby (suspend) mode. The LED will be dark in normal mode and will light in standby (suspend) mode. 15) Keyboard Lock Switch Lead (2-pin KEYLOCK) This 2-pin connector connects to the case-mounted key switch to allow keyboard locking. 16) System Management Interrupt Lead (2-pin EXSMI) This allows the user to manually place the system into a suspend mode or "Green" mode, where system activity is decreased to save electricity and expand the life of certain components when the system is not in use. This 2-pin connector connects to the case-mounted suspend switch. If you do not have a switch for the connector, you may use the "Turbo Switch. " SMI is activated when it detects a short to open moment and therefore leaving it shorted will not cause any problems. This may require one or two presses depending on the position of the switch. The keyboard can always allow wake-up but not the SMI lead. 17) System Warning Speaker Connector (4-pin SPEAKER) This 4-pin connector connects to the case-mounted speaker. Connect the power supply cord to the power supply located on the back of your system case according to your system user's manual. Connect the power cord to a power outlet that is equipped with a surge protector. You may then turn ON your devices in the following order: a. External SCSI devices (starting with the last device on the chain) c. Your system power For ATX power supplies, you need to switch ON the power supply if a switch is provided as well as press the ATX power switch on the front of the case. The power LED on the front panel of the system case will light. For ATX power supplies, the system LED will light when the ATX power switch is pressed. The LED on the monitor may light up or switch between orange and green after the system's if it complies with "green" standards or if it has a power standby feature. The system will then run power-ON tests. While the tests are running, additional messages will appear on the screen. If you do not see anything within 30 seconds from the time you turn ON the power, the system may have failed a power-ON test. [. . . ] Configuration options: [Off] [1~2 Min] [2~3 Min]. . . [1 Hour] HDD Power Down [15 Min] This field shuts down any IDE hard disk drives in the system after a period of inactivity as set in this user-configurable field. This feature does not affect SCSI hard drives. Configuration options: [Disabled] [1 Min] [2 Min] . . . [15 Min] State after a Power Failure [Auto] This allows you to set whether you want your system to reboot after the power has been interrupted. [Off] leaves your system OFF and [On] reboots your system. [. . . ]