User manual ATIKA ASP 11 N

[. . . ] Symbols machine / operating manual Extent of delivery Proper use Residual risks Safe working Start-up Working with the log splitter Maintenance and care Guarantee Possible problems Technical data Declaration of Conformity Spare parts 9 9 9 9 10 11 11 13 14 15 15 60 61 Read the operating and safety instructions thoroughly before commissioning the machine. Wear safety shoes when working with the machine to protect the feet from falling logs. Wear safety gloves when working with the machine to protect the hands from chips and splinters. Wear safety goggles when working with the machine to protect the eyes from chips and splinters. [. . . ] The motor will not be able to provide its maximum performance and the operation of the machine will be impaired. When laying the connecting attachments, be sure that they do get crushed or bent, and that the plug-and-socket connection does not get wet. Do not use the cable for purposes for which it is not meant. Protect the cable against heat, oil and sharp edges. Do not use the cable to pull the plug from the socket. Regularly check the extension cables and replace them if they are damaged. Do not use any defective connection cables. When working outdoors, only use extension cables especially approved and appropriately labelled for outdoor use. Do not set up any provisional electrical connections. The electrical connection or repairs to electrical parts of the machine must be carried out by a certified electrician or one of our customer service points. Local regulations ­ especially regarding protective measures ­ must be observed. - logs with a diameter of over 250 mm can be split if the fibres are smooth and open. Dry logs are much easier to split, and do not cause jams as often as green (damp) wood. Wait a few moments until the motor has reached its operating revolutions and the required pressure has been built up in the hydraulic pump ­ Fig. Press both operating handles down simultaneously ­ Fig. The log ram will now return to its original starting position ­ Fig. Additional SAFETY INSTRUCTIONS The log splitter may only be operated by a single person. The machine may only be operated by persons over the age of 18 years, and who have read and understood these operating instructions. Wear protective equipment (safety goggles/mask, gloves, safety shoes) to protect yourself from possible injury. The logs to be split should be cut to the maximum dimensions (370 mm long, 50 ­ 250 mm). Ensure also that the logs are cut straight and square. Place the log properly on the log splitter, so as not to cause any risk of stumbling or falling to the operator. [. . . ] If the oil level is below the lower marking, more oil should be added with the aid of a clean funnel. Log ram Bleed screw Piston rod Dipstick Cylinder cover Check the oil seal and replace it if it is damaged in any way. Replace the dipstick and screw it firmly into place. Do not tighten the screw too tightly, since this may damage the oil seal or the thread in the cylinder cover. [. . . ]