User manual ATIKA ASP 5-UG

[. . . ] Electrical devices do not go into the domestic rubbish. According to the European Directive 2002/96/EC on electrical and electronic scrap, electrical devices that are no longer serviceable must be separately collected and brought to a facility for an environmentally compatible recycling. Do not operate machine before having read the operating instructions, understood all the notes and assembly the machine as described here. Keep the instructions in a safe place for future use. [. . . ] Then, put the wheels (H) on the axle of the rear rod (G) on both sides. secure the wheels (H) using the circlips. Put the rear support legs (E, F) through the dedicated openings of the rear rod (G) and tighten the hexagon screws (M8x16). Next, put the rear rod (D) on the rear support legs (E, F) and tighten also the hexagon screws (M8x16). Put the middle rod (B) into the rear rod (D). Put the middle rods (B, C) in the dedicated opening of the front support leg (A). tighten the hexagon screws (M8x16) to fix the rods. Fix the handle (J) on the front support leg (A). Electrical connections must conform to IEC 60245 (H 07 RN-F) with a cable cross-section of at least 1. 5 mm² for a maximum cable length of up to 10 m Never use the machine with a power supply cable of over 10 m in length. longer power supply cables will cause a drop in voltage. The motor will not be able to provide its maximum performance and the operation of the machine will be impaired. When laying the connecting attachments, be sure that they do get crushed or bent, and that the plug-and-socket connection does not get wet. Do not use the cable for purposes for which it is not meant. Protect the cable against heat, oil and sharp edges. Do not use the cable to pull the plug from the socket. Regularly check the extension cables and replace them if they are damaged. Do not use any defective connection cables. When working outdoors, only use extension cables especially approved and appropriately labelled for outdoor use. A second person must hold the log splitter in vertical position. Together with the second person lift the log splitter and put it onto the stand. Make also sure that the log splitter safely rests on the front support leg (A) and rear rod (D). [. . . ] Do not drop or lose the oil seal when removing the dipstick. Now tip the machine to empty the oil into the container. Stand the log splitter on end, with the filler opening at the top. Check the oil seal and replace it if it is damaged in any way. [. . . ]