User manual ATIKA FOCUS 185

[. . . ] Fit the table into the appropriate mounting angles. Do not operate machine before having read the operating instructions, understood all the notes and assembly the machine as described here. Dispose of the old oil properly (local oil disposal point). The old oil must not be poured into the ground or drainage system, or mixed with other waste. [. . . ] Do not leave the machine standing in the rain or use when raining. Store the unused machine in a dry locked place away from the reach of children. Switch the machine off and remove the mains plug from the socket when - carrying out repair works - maintenance and cleaning work - checking connecting lines, whether these are knotted or damaged - removing faults - transporting - leaving unattended (even during short interruptions) Check the machine for possible damage - Before continuing to use the machine, the protective devices must be inspected to ensure that they work perfectly and with their intended function - Check whether the movable parts function perfectly and do not stick or whether the parts are damaged. all parts must be correctly installed and fulfil all conditions to ensure perfect operation of the machine. - Damaged guards and parts must be properly repaired or exchanged by a recognized, specialist workshop; insofar as nothing else is stated in the instructions for use. - Damaged or illegible safety warning labels should be replaced immediately. Electrical connections must conform to IEC 60245 (H 07 RN-F) with a cable cross-section of at least 400 V 3~ 5 x 1. 5 mm² for a maximum cable length of up to 10 m Never use the machine with a power supply cable of over 10 m in length. longer power supply cables will cause a drop in voltage. The motor will not be able to provide its maximum performance and the operation of the machine will be impaired. Plugs and coupler outlets on connection cables must be made of rubber, plasticised PVC or other thermoplastic material of same mechanical stability or be covered with this material. The log splitter can be easily transported in this position. Make sure that the oil tank cap is securely tightened to prevent oil from leaking during transport. Oil dipstick If the hydraulic system is not vented, the trapped air will damage the seals and cause permanent damage to the log splitter. Compare the voltage given on the machine model plate e. Only use connection cables with sufficient cross-sections. Connect the machine via a 30 mA fault current safety switch. Do not use any device where the switch can not be switched on and off. Damaged switches must be repaired or replaced immediately by the customer service. Additional SAFETY INSTRUCTIONS The log splitter may only be operated by a single person. The machine may only be operated by persons over the age of 18 years, and who have read and understood these operating instructions. Wear protective equipment (safety goggles/mask, gloves, safety shoes) to protect yourself from possible injury. [. . . ] Place a container under the log splitter to catch the old oil. The container should have a capacity of at least 10 litres. Screw off the drain plug to allow the oil to flow out. Replace the dipstick fully into the oil reservoir. [. . . ]