User manual ATIKA KSH 600

[. . . ] Declaration of conformity Extent of delivery Operating times Symbols on the chain saw Symbols Operating instructions Normal intended use Residual risks Security instructions - Electrical safety Assembly Before the first commissioning - Chain lubrication - Charging the oil tank Commissioning - Mains connection - Mains fuse - Electrical mains supply impedance - Switching On/Off - Chain brake - Checking of chain brake - Clamping of saw chain Working with the chain saw - Before sawing - Saw backstroke - How to avoid backstrokes - General conduct when sawing - Additional advices for sawing trunks - Additional advices for sawing timber under tension/release - Additional advices for chopping down trees Maintenance and cleaning - Maintenance - Sharpening of saw chain - Exchanging saw chain and sword - Chain wheel - Checking of the oil automatic - Cleaning Transport Storage Guarantee Technical data Possible faults Discription of chain saw / Spare parts 17 17 17 18 18 18 18 18 20 20 20 20 20 21 21 21 21 21 21 21 21 22 22 22 22 22 23 23 23 24 24 24 24 24 24 25 25 25 25 25 26 26 / 177 KG Schinkelstraße 97 59229 Ahlen - Germany declare under our sole responsibility, that the product chain saw typ KS 2001/40, KS 2201/40 to which this declaration relates corresponds to the relevant basic safety and health requirements of the Directive 98/37/EC, and to the requirements for the other relevant Directives: 2004/108/EG, 2006/95/EC. conformity assessment procedure:2000/14/EC-Appendix V. Measured sound power level LWA 104 dB (A) Guaranteed sound power level LWA 105 dB (A) After unpacking, check the contents of the box > That it is complete > Check for possible transport damage Report any damage or missing items to your dealer, supplier or the manufacturer immediately. Complaints made at a later date will not be acknowledged. [. . . ] Put the chain saw with motor facing downward on an even face. 1 Compare the voltage given on the machine model plate e. 230 V with the mains voltage and connect the saw to the relevant and properly earthed plug. Use a shockproof plug, mains voltage 230 V with residual current circuit breaker (FI switch 30 mA). Only use connection cables with sufficient diameters. Do not use a device where - the contactor can not be switched on and off. - the chain and motor brake does not work properly Damaged switches must be repaired or replaced immediately by the customer service. When switching on the chain saw must be supported and held safely. After finishing the sawing works release tension of saw chain as in case of cooling too high tensions would emerge in the saw chain. If chain flackers or comes out of the guide clamp it again immediately. Put the chain saw with motor facing downward on an even face. + Hold the chain saw always firmly with both hands, left hand on the front handhold (4) and right hand on the rear handhold (17). 14 + Make sure that the wood can not turn when sawing. There is risk of injury by wood pieces carried away. + Initiate saw chain before getting in contact with the wood. + Only cut the sawing material with the lower edge. Cutting with the upper edge causes saw backstrokes. + Put on the chain saw as plane as possible. + Use the claw stopper (16) for fixing the chain saw on the wood. Use the claw stopper when sawing as lever. 16 + When sawing thicker perches or trunks set back the claw stopper (16) on a deeper point. For setting back release the claw stopper from the wood and place it again in a deeper position. [. . . ] 24 In case of harder pollution or resins put the chain for some hours in a container with chain cleaner. Afterwards wash up the chain with clear water. Remove all adhering substances with a brush from the chain wheel and the sword fastening. Clean the oil flow canal with a clean cloth. [. . . ]