User manual ATIKA KSH 600.... BROCHURE

[. . . ] Fit the table into the appropriate mounting angles. Do not operate machine before having read the operating instructions, understood all the notes and assembly the machine as described here. Wear hearing protection when working with the machine to protect your hearing. Wear face mask when working with the machine to protect the eyes from chips and splinters. [. . . ] Impairment of hearing when working on the machine for longer periods of time without ear protection. In addition, in spite of all the precautionary measures taken, nonobvious residual risks can still exist. Check the machine for possible damage - Before continuing to use the machine, the protective devices must be inspected to ensure that they work perfectly and with their intended function - Check whether the movable parts function perfectly and do not stick or whether the parts are damaged. all parts must be correctly installed and fulfil all conditions to ensure perfect operation of the machine. - Damaged guards and parts must be properly repaired or exchanged by a recognized, specialist workshop; insofar as nothing else is stated in the instructions for use. - Damaged or illegible safety warning labels should be replaced immediately. The log splitter can be easily transported in this position. Make sure that the oil tank cap is securely tightened to prevent oil from leaking during transport. Electrical connections must conform to IEC 60245 (H 07 RNF) with a cable cross-section of at least 230 V ~ 3 x 1. 5 mm² for a maximum cable length of up to 10 m 400 V 3~ 5 x 1. 5 mm² for a maximum cable length of up to 10 m Never use the machine with a power supply cable of over 10 m in length. There are no damages at the machine all screws are tight check the hydraulic system for any possible leaks the oil level Vent the hydraulic system before putting the log splitter into operation. Unscrew the oil cap by several turns so that air may escape from the oil tank. Leave the oil cap open during operation. Move the splitting blade right down every time before the machine is transported. Close the oil cap before moving the log splitter, as otherwise oil will leak at this point. Never operate the machine in the event of any possible danger from hydraulic fluid. Ensure that the machine and working area are clean and free of oil. Check the hydraulic reservoir regularly to ensure that it contains enough hydraulic oil (see "Care and maintenance"). Compare the voltage given on the machine model plate e. Only use connection cables with sufficient cross-sections. Connect the machine via a 30 mA fault current safety switch. [. . . ] Place a container under the log splitter to catch the old oil. The container should have a capacity of at least 4. Screw off the drain plug to allow the oil to flow out. Replace the dipstick fully into the oil reservoir. [. . . ]