User manual ATIKA MHD 2500 BROCHURE

[. . . ] Hopper opening for material to be shredded Safety cut-off screw Motor protection On / Off switch Main plug Ventilation apertures Carriage Ejection slot You may not start to operate the machine until you have read these operating instructions, observed all the instructions given and installed the machine as described!Keep the instructions in a safe place for future use. Electrical devices do not go into the domestic rubbish. Carefully read the operating manual and the safety instructions before starting the machine and observe the instructions when operating. [. . . ] Do not modify the device or parts of the device respectively. Close machine properly before enabling motor. Take into consideration environmental influences: - Do not use the device in moist or wet ambience. - Do not leave the machine standing in the rain or use when raining. Switch the machine off and remove the mains plug from the socket when - Performing maintenance and cleaning work. - Checking connecting lines, whether these are knotted or damaged. If the machine's filling funnel or ejection slot is blocked switch off the motor and disconnect the mains plug before removing material from the filling funnel or ejection slot. Check the machine for possible damage: - Before further use of the machine the safety devices must be checked carefully for their proper and intended function. - Check whether movable parts function perfectly and do not stick or whether parts are damaged. all parts must be correctly installed and fulfil all conditions to ensure perfect operation of the machine. - Damaged safety devices and parts must be properly repaired or exchanged by a recognized, specialist workshop; insofar as nothing else is stated in the instructions for use. - Damaged or illegible safety labels have to be replaced. Store unused equipment in a dry, locked place out of the reach of children. Design of the connection cable according to IEC 60 245 (H 07 RN-F) with a core cross-section of at least - 1. The motor does not reach any longer its maximal power; the function of the device is reduced. Plugs and coupler outlets on connection cables must be made of rubber, plasticised PVC or other thermoplastic material of same mechanical stability or be covered with this material. the connector of the connection cable must be splash-proof. When running the connection line observe that it does not interfere, is not squeezed, bended and the plug connection does not get wet. Wind off completely the cable when using a cable drum. Do not use the cable for purposes for which it is not meant. Protect the cable against heat, oil and sharp edges. Do not use the cable to pull the plug from the socket. [. . . ] Hedge and tree cuttings, dead flowers and vegetable kitchen waste. no: · Glass, metal, plastic, plastic bags, stones, cloth, roots with soil, food left-overs, fish or meat. The cutters will not come to a standstill immediately after cut-off. Before starting any service work wait until all parts are stationary. [. . . ]