User manual ATIKA PROFI 145 S BROCHURE

[. . . ] Any other utilisation counts as improper use, especially mixing combustible or explosive materials ( fire and explosion hazard) and use with foodstuffs. The manufacturer is not liable for damages resulting from improper use. The intended usage also includes compliance with the operating, servicing and repair conditions prescribed by the manufacturer and following the safety instructions included in the instructions. The relevant accident prevention regulations for the operation as well as the other generally acknowledged occupational medicine and safety rules must be complied with. [. . . ] - unusual noises and vibrations Thoroughly maintain your agitator: - Make sure that the ventilation apertures are free. - Keep handles dry and free of oils and grease. Check the machine for possible damage: - Before further use of the machine the safety devices must be checked carefully for their proper and intended function. all parts must be correctly installed and fulfil all conditions to ensure perfect operation of the machine. - Damaged guards and parts must be properly repaired or exchanged by a recognized, specialist workshop; insofar as nothing else is stated in the instructions for use. - Damaged or illegible safety labels should be replaced immediately. Store unused equipment in a dry, locked place out of the reach of children. Even if used properly, residual risks can exist even if the relevant safety regulations are complied with due to the design determined by the intended purpose. Residual risks can be minimised if the "Safety instructions" and the "Normal intended use" as well as the whole of the operating instructions are observed. Observing these instructions, and taking proper care, will reduce the risk of personal injury or damage to the equipment. Failure to observe the safety precautions can lead to injury to the operator or damage to property. 5 m featuring a core cross section of at least 25 mm² Do not use any device where the switch can not be switched on and off. Damaged switches must be repaired or replaced immediately by the customer service. The device will slowly start after powering up. As you press more firmly on the button the rotational speed also increases. For the speed selection turn the switch (6) by 180°. Use the agitator only in continuous mode with the agitator stand fitted. Before each use, check - Connection cables for defects (cracks, cuts, etc. With this type, the motor's speed and thus the agitator performance can be adjusted. You can continuously adjust the speed with the speed control (4). Compare the voltage given on the machine model plate e. If persons who have blood circulation problems are too often exposed to vibrations damages to the nervous system or to blood vessels may occur. [. . . ] Observe the following to maintain the operability of the machine: Keep vent slits clean and free from obstructions. Remove dust and dirt using a cloth or a soft brush. Do not clean the machine with running water or highpressure cleaners. Do not use solvents for the synthetic parts (petrol, alcohol, etc. [. . . ]