User manual ATIKA PROFI RW 1400-2 BROCHURE

[. . . ] Electrical devices do not go into the domestic rubbish. KG Schinkelstraße 97 59227 Ahlen - Germany declare under our sole responsibility, that the device Handhel Agitator Profi RW 1400-2 / Profi RW 1800-2 to which this declaration relates corresponds to the relevant basic safety and health requirements of the Directive 98/37/EC, and to the requirements for the other relevant Directives: 2006/95EG, 2004/108 EG and EN 60745-1 This agitator is suited for DIY work for mixing liquid and powdry building material such as: paints, mortar, adhesives, plaster, grouting compounds, knifing fillers, coating compounds. Only beaters intended for the device with a max. diameter of 140 mm (Profi RW 1400-2) or 160 mm (Profi RW 18002) must be used. [. . . ] Risk from electricity, by using non-standard electrical connections. Touching live parts of opened electrical components. Impairment of hearing when working on the machine for longer periods of time without ear protection. In addition, in spite of all the precautionary measures taken, non-obvious residual risks can still exist. Design of the connection cable according to IEC 60 245 (H 07 RN-F) with a core cross-section of at least 3 x 1. The motor does not reach any longer its maximal power; the function of the device is reduced. Plugs and coupler outlets on connection cables must be made of rubber, non-rigid PVC or other thermoplastic material of same mechanical stability or be covered with this material. the connector of the connection cable must be splashproof. When running the connection line observe that it does not interfere, is not squeezed, bended and the plug connection does not get wet. Wind off completely the cable when using a cable drum. Regularly check the extension cables and replace them if they are damaged. Do not use any defective connection cables. Do not set up any provisional electrical connections. never bypass protective devices or deactivate them. Only hook up the machine by means of a fault-current circuit breaker (30 mA). The electrical connection or repairs to electrical parts of the machine must be carried out by a certified electrician or one of our customer service points. Repairs to other parts of the machine must be carried out by the manufacturer or one of his customer service points. Accidents can arise for the user through the use of other spare parts. The manufacturer is not liable for any damage or injury resulting from such action. Connect the machine via a 30 mA fault current safety switch. Do not use any defective connection cables. use connecting or extension cables up to a length of 1. [. . . ] Before each fault elimination: - switch off device - wait for standstill of the beater - pull out power plug After each fault clearance, put into operation and recheck all security installations. Check fuses (10 A) exchange defect cable, respectively check extension cable, (by electrician) Never use defect lead To correct the problem, refer to the manufac Motor or switch defect turer or other approved service centre. To correct the problem, refer to the manufacturer or other approved service centre. Follow the processing instructions from the supplier. [. . . ]