User manual ATIKA T 250 BROCHURE

[. . . ] Do not operate machine before having read the operating instructions, understood all the notes and assembly the machine as described here. Keep the instructions in a safe place for future use. Electrical devices do not go into the domestic rubbish. Do not screw any of the screw connections tight just yet! [. . . ] The use of other tools and other accessories can signify a risk of injury for you. It is set in the works so that its distance from the toothed ring above the table must Switch the machine off and remove the mains plug from the socket when - carrying out repair works - carrying out servicing and repair works, removal of faults (this also includes removing clamped splinters) - Transporting the saw - Changing the saw blade - leaving the saw unattended (even during short interruptions) Look after your saw with care: - Keep the tools sharp and clean to be able to work better and more safely. - Follow the servicing instructions and the information about changing tools. - Keep handles dry and free of oils and grease. Check the machine for possible damage: - Before continuing to use the machine, the protective devices must be inspected to ensure that they work perfectly and with their intended function - Check whether the movable parts function perfectly and do not stick or whether the parts are damaged, All parts must be correctly installed and fulfil all conditions to ensure perfect operation of the saw - Damaged guards and parts must be properly repaired or exchanged by a recognized, specialist workshop; insofar as nothing else is stated in the instructions for use. Do not allow any tool key to be plugged in!Store the unused machine in a dry locked place away from the reach of children. Do not use the saw for unsuitable purposes (see 'Normal intended use'). When longitudinally cutting narrow workpieces (distance between the saw blade and the parallel rip fence less than 120 mm), use the pushstick. To push narrow workpieces against the parallel rip fence, use a pushstick. The upper saw blade guard must always be used. It must be adjusted so that the toothed ring is covered except for the part required for machining the workpiece. Ensure that cut off pieces are not caught up by the saw blade and projected away. Do not remove splinters, chips and waste from the hazardous area of the saw blade by hand. It is not permissible to use wobble devices and groove milling tools. Cutting logs with the standard feed guides is not permissible. When cutting logs, use a special device, which secures the workpiece on both sides of the saw blade against turning. Design of the connection cable according to IEC 60 245 (H 07 RN-F) with a core cross-profile section of at least - 1. Avoid touching earthed parts with your body. Do not use the cable for purposes for which it is not meant. Protect the cable against heat, oil and sharp edges. Do not use the cable to pull the plug from the socket. [. . . ] Ensure that the saw blade remains free of rust and resin · Remove all resin residues from the saw bench top 23 The saw blade is a wearing part and becomes blunt after long or frequent use renew the saw blade or have it sharpened We grant a guarantee of two years, commencing with the day of delivery from the dealer's store, for material and manufacturing faults. Warranty claims, even during the warranty period, will not be accepted for damages due to incorrect handling or inadequate packaging during return of the devices or to a non-observance of the operating instructions. Faulty parts must be sent to our works, postage or freight free. We reserve the right to decide upon free spare part delivery. [. . . ]