User manual ATLANTIC ULYSSE

[. . . ] - The device must be supplied Panel heater cable with 230V, 50Hz. - Mains connection must be ensuPhase=brown PHASE red using the 3-wire cable factoElectricity grid ry fitte to the device, through a NEUTRAL Neutral=blue connecting box. In damp premiPilot wire=Black ses, such as bathrooms and kitchens, install the connecting box Three possible cases at least 25cm from the ground. - The installation must comply The pilot wire end is insulated 1st case: only one heater and not further connected with local national regulation. [. . . ] If To the appliance with cassette or in doubt, ask the national 2nd case: Slave heater programming unit. - If power cable is damaged or too short, to avoid any danger it must be replaced by a qualified electrician using special tools. Bathroom), the pilot wire supply must be protected on this differential. Chart indicating the orders the device can receive over its pilot wire B) Set wheel B, the heating indicator C lights up if the ambient temperature is lower than the temperature desired. c) Wait a few hours for the temperature to stabilise. D) If the setting suits you (use a thermometer to check, if need be), mark the position once and for all. If you do not like the setting, readjust it and return to point c. 3) Anti-Frost mode This mode enables you to maintain the temperature in the room at around 7°C during prolonged absences from home (generally more than 24 hours). 4) Turbo Max 2h mode This mode enables you to increase the room's temperature rapidly and to heat your towels. Wait for approximately 15 minutes and then restart the device. - This device is not intended for use by persons (including children) with physical, sensory or mental disability, or by persons lacking experience or knowledge, unless they have received from a person in charge of their safety adequate supervision or preliminary instructions on how to use the device. - Please ensure that children do not lean on the device or play close to it when it is operating : its surface may be hot enough to cause burns to their skin in some circumstances, particularly because their reflexes may not yet have been acquired or are slower than those of an adult. If there is any risk, fit a protective grill in front of the device. - Take care not to allow any foreign bodies or paper to enter the device. - Any work inside the device must be done by a qualified professional tradesman. - When conducting any work on the device, it is essential that it be set to the STOP position and have cooled down before being unhooked from its bracket. - To maintain the device's performance, the upper and lower grills must be cleaned with a vacuum cleaner or a brush approximately twice a year. - Every five years, have the internal components checked by a qualified electrician (cleaning and interfacing). [. . . ] - To maintain the device's performance, the upper and lower grills must be cleaned with a vacuum cleaner or a brush approximately twice a year. - Every five years, have the internal components checked by a qualified electrician (cleaning and interfacing). - In dirty environments, stains may appear on the device's grill. This is caused by poor quality ambient air. [. . . ]