User manual ATLAS AKF2358A

[. . . ] · Warnings and Important Safety Instructions in this manual do not cover all possible conditions and situations that may occur. It is your responsibility to use common sense, caution, and care when installing, maintaining, and operating your appliance. · Because these following operating instructions cover various models, the characteristics of your refrigerator may differ slightly from those described in this manual and not all warning signs may be applicable. If you have any questions or concerns, contact your nearest service center or find help and information online at www. samsung. com. [. . . ] This will help reduce power consumption and keep your energy bills lower. · Do not install the refrigerator in a place with the temperature lower than 10°C. Pull the unit straight out when installing, servicing or cleaning behind the refrigerator and push it straight back after work is complete. Make sure your floor can support fully loaded refrigerator. CAUTION setting up _07 REVERSING THE REFRIGERATOR DOOR WARNING 3. Disconnect the wire and then remove 3 bolts on the top of the refrigerator. Before you reverse the refrigerator door, make sure to unplug the refrigerator. If this operation is not performed by After sales service, it is not covered by the warranty. Required Tools CAUTION Make sure the Fridge door is closed firmly. Remove the Fridge door from the Middle hinge by carefully lifting the door straight up. Not provided Phillips Head Driver (+) Flat Head Driver (-) 10mm Socket Wrench (for bolts) Not provided Additional part Middle hinge 11mm Wrench (for hinge shaft) 3/16" Allen Wrench (for middle hinge) Top Left Hinge Cover (Underneath the Top Cover) CAUTION Fridge door is heavy, be careful not to injure yourself when removing the Fridge door. 1. Remove 4 screws on the Top cover of the refrigerator. 5. Disassemble the Middle hinge by removing 2 bolts and a screw on the right side. Remove the Freezer door from the Bottom hinge by carefully lifting the door straight up. Middle hinge Screw WARNING Make sure your refrigerator is unplugged before handling electrical wires. Bottom hinge 2. Make sure to disconnect the wire underneath the Top cover. CAUTION Freezer door is heavy, be careful not to injure yourself when removing the Freezer door. CAUTION Be careful not to damage the electrical wires when removing the Top cover. 08_ setting up REVERSING THE REFRIGERATOR DOOR (CONT'D) 6. Separate the Front leg cover after removing 2 screws. 10. Switch the side of bottom hinge cap and then attach the Front leg cover on the bottom of the refrigerator. Bottom hinge cap 01 SETTING UP Screw Front leg cover 11. Switch the side of the Middle hinge cap, Screw cap and a Screw from left to the right side. 7. Hooks inside of the door handles can break easily. setting up _11 3. Assemble the handles after switching the side of the Fridge handle and the Freezer handle. 3. Change the positions of the Handle slider and spring from the left side to the right side. Make sure to change position of the Handle slider cap from the right side to the left side. Slider Spring 4. Tighten 2 screws underneath the Fridge door and then assemble 2 screws and 2 Cap sheets on the Freezer door. Assemble the door handle by following step 2 and 1 in reverse order. Screw This procedure must be done before `Reversing the Refrigerator Door' step 23. LEVELLING THE REFRIGERATOR REVERSING THE DOOR HANDLE (TYPE B) 1. Remove 2 screws underneath the Fridge door and then pull the Handle cover. If the front of the appliance is slightly higher than the rear, the door can be opened and closed more easily. Turn the adjusting legs clockwise to raise and counter-clockwise to lower the height. Case 1) The appliance tilts down to the left. · Turn the left adjusting leg in the direction of the arrow until the appliance is level. Screw Cover handle Case 2) The appliance tilts down to the right. [. . . ] (Fresh safe drawer / Cool select zone drawer / Cooler zone drawer / Freezer Drawers ) 18_ operating troubleshooting PROBLEM The appliance is not operating at all or the temperature is too high. SOLUTION · · · · Check if the power plug is correctly connected. Is the temperature control on the front panel correctly set?Does sun shine on the appliance or are there any heat sources nearby? [. . . ]