User manual ATLINKS TEMPORIS 23

[. . . ] Slide the RINGER volume (on the base) to the desired volume. Slide the PULSE/TONE switch to TONE if you use Touch-Tone Thomson Model Temporis to PULSE if you have rotary service. Telecom Service; set it 23-RS 46 00030362 (Rev. 1 R/E) into the handset. Plug thean RJ11 type modular jack, which is the handset cord 2 You Boulogne Billancourt 09-43 need telephone line cord into a 1 92100wall phone jack. [. . . ] To get the most from your under license by ATLINKS. Alcatel logo Thomson read through this Model Temporis 23-RS a few minutes right now to Telecom suggest that you take 46 quai Alphonse le Gallo 00030362 (Rev. 1 R/E) instruction manual. INTRODUCTION ATLINKS 22 quai Gallieni 92150 Suresnes France www. atlinks. com 1. When the phone rings, simply lift the handset and begin your wall plate (not included). Plug the telephone line cord into 2 a modular wall phone jack. To end of conversation, return the handset to cradle. Slip the mounting holes on the 1 base over the wall plate posts and A CALL firmly slide the unit down into place. You may control therings, simply lift the handset and begin your 1. When the phone ringer volume level with theswitch located on conversation. the bottom of THE = ringer tone will be loud In To end ofmode, you may wantthe wrap theto cradle. desktop conversation, return to handset excess 2. = ringer tone will be middle telephone line cord through the grooves provided on the TELEPHONE BASICS WALL MOUNT INSTALLATION RECEIVING may also be mounted on a Your telephone A PHONE CALL C TELEPHONE BASICS RINGER VOLUME RECEIVING PHONE WRAPPING TELEPHONE LINE CORD T g WRAPPING THE TELEPHONE LINE CORD In desktop mode, you may want to wrap the excess telephone line cord through the grooves provided on the bottom of the base. 2. Slip the mounting holes on the base over the wall plate posts and firmly slide the unit down into place. 1 1. Feedback when dialing This is normal, Power fluctuates with in PULSE mode phone outpulsing. If you have Pulse Can't be heard by(rotary) service, and phone cord is securely Make sure want to access customer calling services other party plugged as that require touch-tone dialing, suchin. getting information from a Make sureyou phones aren't off the local bank, other hook at the same time you're using the can use this feature. Press the TONE button ( * ) after you when additional phones are used at the have connected to the service in order to enable touch-tone same time. dialing. TONE button TEMPORARY TONE FEATURE 2. When you hang up, the phone autoCARE AND MAINTENANCE 1. When the phone rings, simply lift the handset and begin your conversation. TELEPHONE BASICS RECEIVING A PHONE CALL RINGER VOLUME 2. To end of conversation, return the handset to cradle. You may control the ringer volume level with theswitch located on the bottom of the base. = ringer tone will be loud = ringer tone will be middle = ringer tone will be low. PLACING A PHONE CALL FLASH BUTTON 1. Lift the handset and wait for a dial tone. [. . . ] 5 years Life cycle TROUBLESHOOTING TIPS PROBLEM SOLUTION CARE REDIAL BUTTON TEMPORARY TONE FEATURE If you have Pulse (rotary) service, and want to access customer calling services that require touch-tone dialing, such as getting information from a local bank, you can use this feature. 2. To keep your phone working and looking good, follow these guidelines: Avoid putting near heating appliances and devices that generate electrical noise (for example, motors and fluorescent lamps). DO NOT expose to direct sunlight or moisture. Avoid dropping and other rough treatment of the unit. [. . . ]