User manual AUDIO ANALOGUE DONIZETTI CENTO

[. . . ] No part of this manual can be reproduced by any means, transmitted or copied for private or public use without private authorization from AUDIO ANALOGUE. The information contained in this manual is related to the data kept by AUDIO ANALOGUE at the moment of the issue o f this publication; AUDIO ANALOGUE has the right to make changes to this document without prior notice. the equipment has been projected and manufactured according to the Regulations of the Community 89/336/CEE and is marked CE. This equipment can't be used for different purposes other than those for which it has been manufactured. [. . . ] This operation should be only made prior to disconnecting the main supply. Do not place objects on the supply cable and check that this is not positioned in way through. Do not use the equipment close to the water or other liquids. If liquid entered the equipment, the plug should be disconnected from the socket avoiding to touch the metal parts. Competent technical staff should be asked to check the equipment before operating it again. Keep the equipment far from sources of heat such as the solar light, kitchens, radiators etc. Always unplug the supply cable during rainy weather. Always Switch off and unplug the supply cable before cleaning the equipment externally. : this operation should be made using a dry and soft cloth. never use alcohol based cleaning material. If the amplifier was carried from an extremely cold environment to and extremely hot one, it could create internal condensation, causing possible bad functioning. If this occurs, please wait for at least an hour before using it again, to allow it to gradually reach room temperature. when not used for long periods , please unplug the equipment. INSTRUCTIONS TO PUT IT OUT OF SERVICE Consult qualified staff Follow the regulations of the current legislation regarding recycling and waste disposal. 12V trigger input to control the unit through another unit. If necessary, replace them with others of the same kind (see back panel). If one of the items listed above is missing, please contact your Audio Analogue retailer. After extracting the smallest items from the package, pull out the unit carefully. Where to place Donizetti Cento Donizetti Cento is a complex unit that may generate a large quantity of heat. please locate the unit in a well-ventilated place. Particularly, you should leave at least 5cm around and above the unit and avoid placing it close to heat sources (radiators, heaters, amplifiers, television sets). Plugging in and connecting Donizetti Cento Before connecting Donizetti Cento to a preamplifier, be sure that they are both unplugged from wall outlets. [. . . ] As an example, if you build up a bi-amplified system with a Bellini VB and two Donizettis Cento using the Bellini outputs to control the other units, it is possible to turn on all the three units through the Bellini remote controller by connecting the Bellini trigger out to a Donizetti trigger in and that Donizetti trigger out to the other Donizetti trigger in. It is obviously possible to use the trigger output to control any other unit equipped with a compatible trigger input. A trigger cord is usually found in the preamplifier package: if necessary, it is possible to buy trigger cords at your local Audio Analogue retailer. SPECIFICATIONS Parameter Channels: Gain Frequency response Measurement conditions 20Hz-20kHz Balanced in, 1Vrms out Balanced in, 28Vrms out Single-ended in, 1Vrms out Single-ended in, 28Vrms out Single-ended in, Band limits 0Hz-48kHz, inputs closed on 20 Ohm Balanced in, Band limits 0Hz-48kHz, inputs closed on 40 Ohm Single-ended in, 22Hz-22kHz Balanced in, 22Hz-22kHz Balanced in, Pout=100W @ 8 Ohm Single-ended in, Pout=100W @ 8 Ohm R->L, L->R, 1Vrms @ 1kHz on the interfering channel, measured channel input closed on 20 Ohm, 20Hz-20. [. . . ]