User manual AUDIO ANALOGUE PUCCINI SETTANTA REV2.0

[. . . ] Integrated-resistors network volume controls with no buffer for maximum sound transparency. INTRODUCTION AUDIO ANALOGUE does not take any responsibilities in the following cases: Whenever the operational procedures related to the use and the maintenance of the equipment as described in this manual are not respected. Whenever damages to the equipment occur because of fixing and modifications made form non-authorized staff or because of normal deterioration of the system. No part of this manual can be reproduced by any means, transmitted or copied for private or public use without private authorization from AUDIO ANALOGUE. [. . . ] never use alcohol based cleaning material. If the amplifier was carried from an extremely cold environment to and extremely hot one, it could create internal condensation, causing possible bad functioning. If this occurs, please wait for at least an hour before using it again, to allow it to gradually reach room temperature. when not used for long periods , please unplug the equipment. INSTRUCTIONS TO PUT IT OUT OF SERVICE Consult qualified staff Follow the regulations of the current legislation regarding recycling and waste disposal. One of the six blue leds on its right indicates the selected source. If you press this button when the unit is in Stand-by mode, it will activate. It rotates just for a few degrees because it operates on a switch. Attenuation level is shown by blue leds. Sixteen blue leds around the volume knob progressively indicate the volume level. Record player ground connector (to be used only when phono in is in use) PH/1. IEC standard power inlet with main power supply switch. If necessary, replace them with others of the same kind (see back panel). When pressed and immediately released, it activates/deactivates standby mode. When muting is activated, volume level is reduced to background level and the volume leds start blinking. If one of the items listed above is missing, please contact your Audio Analogue retailer. After extracting the smallest items from the package, pull out the unit carefully. Where to place Puccini Settanta Puccini Settanta is a complex unit that may generate a large quantity of heat. please locate the unit in a well-ventilated place. In particular, you should leave at least 5cm around and above the unit and avoid placing it close to heat sources (radiators, heaters, amplifiers, television sets). Plugging and connecting Puccini Settanta Before connecting Puccini Settanta to the sources, please be sure that they're all unplugged from wall outlets. First of all, connect the sources to the Puccini Settanta inputs you want to use. [. . . ] To activate bypassing it is sufficient to press the "STBY" button on the remote controller for a few seconds when the amplifier is on: on the amplifier front panel will switch-on the led light corresponding to the by-passed input and the two led lights placed on top of volume knob. To de-activate by-pass, hit the STBY button again on the remote control and the amplifier will go back to normal mode. please note that the amplifier is working when in By-pass mode. Do not keep the unit in this mode for a long time. [. . . ]