User manual AUDIO TECHNICA ATLP60

[. . . ] Use only with a cart, stand, tripod, bracket or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over. Unplug this apparatus during lightning storms or when unused for long periods of time. Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped. [. . . ] If your stereo system does not have a PHONO input, set the Pre-amp Selector Switch to the “LINE” position and connect the turntable’s output cables to the AUX or other high-level input on your stereo system (described later) (Fig. Connect the red RCA-type pin-plug to the right channel input and the white RCA-type pin-plug to the left channel input of your stereo system (Fig. With the tone arm still fastened to the tone arm rest, slowly turn the turntable platter clockwise ten times, to make certain the automatic mechanism is fully cycled. Remove the vinyl tie that holds the tone arm on its rest. connect the power cord plug to an AC outlet. Make sure the AC outlet supplies the proper voltage for the AT-LP60 you are using. The first of these adapter cables–dual RCA to stereo 3. 5 mm mini-plug (male)–is designed to fit most popular computer* audio inputs. It may also be used to connect the turntable’s RCA output to other equipment, including: • a stereo/boombox* equipped with a 3. To use either adapter cable, connect the turntable’s red and white RCAtype plugs to the cable adapter’s RCA-type jacks. * When using either cable adapter, always set the AT-LP60 turntable’s Pre-amp Selector Switch to the “LINE” position. (Switch is located on the back of the turntable. ) NOTE: If connection is desired to a mono amplifier/speaker, make certain to use a stereo-to-mono adapter, available from your dealer or an electronic parts store. Inserting a mono plug in the stereo jack will disable one of the stereo channels. Other adapter cable configurations will be available from dealers and parts stores for connecting to devices needing different terminations. 5 mm Input The AT-LP60 connects without adapters to devices equipped with RCA connectors. For maximum flexibility, we have included two adapter cables to fit other popular audio inputs. figure 3 PHONO “AUX” Stereo System Input Jacks White Red AC Pre-amp Selector Switch PHONO LINE AC Operation Automatic Operation 1. Remove the stylus guard from the stylus assembly (Fig. The turntable will start and the tone arm automatically will move to the leadin groove. When the record has finished playing, the tone arm automatically will return to the tone arm rest and the turntable will shut off. Stop: To stop playing the record before it reaches the end, press the STOP button (Fig. [. . . ] In event of such defect, product will be repaired promptly without charge or, at our option, replaced with a new product of equal or superior value if delivered to A. Or an Authorized Service Center, prepaid, together with the sales slip or other proof of purchase date. This warranty excludes defects due to normal wear, abuse, shipping damage, or failure to use product in accordance with instructions. This warranty is void in the event of unauthorized repair or modification, or removal or defacing of the product labeling. [. . . ]