User manual AUDIOLINE STUDIO 80

[. . . ] 47 Dialling stored numbers from the phone book. Entering numbers and names in the phone book. 50 Changing numbers and names stored in the phone book . 51 Deleting stored numbers and names from the phone book . [. . . ] After connecting to an outside line your telephone will wait for 3 seconds before dialling the actual telephone number. The pause can also be saved with numbers in the phone book. The integral answering machine can store up to 12 minutes of incoming messages digitally during your absence. In addition, notes (memos) can be left for other users. Remote interrogation from another telephone is possible. For your greeting message, you can use two pre-recorded standard messages or you can record two messages of your own. If you have not recorded your own greeting, the standard greeting will answer automatically. Before working with the answering machine, you should set the day and time announcement. The answering machine can be switched on or off via the button. The message indicator light will illuminate when the answering machine is switched on. Note: When you switch on the answering machine, you will hear the current greeting with which the machine will answer. If the caller speaks for longer, a signal tone sounds and the call will be cut off. If there is a pause of more than 7 seconds during recording, the call will automatically be terminated with a signal tone. If the memory capacity for new messages is exhausted, the answering machine automatically switches to announcement no. 2), and no further calls can be recorded. You can adjust the volume to suit and buttons on the base station. Your requirements by repeatedly pressing the You will hear a dual signal tone once the minimum or maximum setting is reached. 4 Delaying acceptance of calls Here, you can set up after how many rings incoming calls are to be accepted. This number can be changed to between 2 and 9 rings. the setting for the toll-free remote pre-access facility is also available. In this case, you will hear the words "Sparer". After releasing the button, you will hear the selected setting again. [. . . ] You are too far away from the base station. Before doing so, briefly remove the power supply from the socket. Place the handset properly on the base station, clean the contact surfaces on the handset and on the base station with a soft, dry cloth. place the handset on the base station for 16 hours. [. . . ]