User manual AUDIOLINE TAM828

[. . . ] To record your own announcement message: # Ensure the machine is switched on. # Press and hold the [ANNC/DAY] button, display shows "A1". # After a beep tone record your message (maximum: 30 seconds). # When finished, release [ANNC/DAY] button, your greeting will now replay. [. . . ] # To check the settings, press and release the [TIME SET/CHECK] button. If `Please set time' is announced, the time has not been set. NOTE: If you do not set the time, the system will not announce the time each message was received. ANSWERING CALLS The switch 2/7/TS at the side of the system determines how the system answers calls. 2 = the system will answer a call after 2 rings 7 = the system will answer a call after 7 rings T/S = the system will answer a call after 2 rings if new messages are recorded and after 4 rings if no new message exists. 3 AUDIOLINE TAM828 USING THE ANSWERING SYSTEM VOLUME CONTROL # Press the · ­ buttons to increase/decrease volume. LISTENING TO YOUR MESSAGES # # # The display flashes to show how many new messages have been received. If no new messages have been received the display shows total messages (old). Press [PLAY/PAUSE] to listen to your new messages (when NEW messages have been played, press [PLAY/PAUSE] again to play all messages). You have the following options during playback: Press [SKIP] to skip current message. Press [REPEAT] to replay current message. Press and hold [REPEAT] for 1 second to play previous message. Press [DELETE] to erase current message. # Is the line cord undamaged and connected correctly?# Have you experienced a storm recently?CALLS ARE NOT ANSWERED # Check that the unit is switched on and set to answer mode. THE UNIT DOES NOT RECORD MESSAGES # Is there a mains power failure?The unit will not operate with no power. The backup battery (if fitted) will only retain your messages, it will not power the units normal operation. MESSAGES CANNOT BE HEARD # Is the volume control set to the lowest level?MESSAGES ARE LOST AFTER A POWER FAILURE # Insert or replace the battery when display shows "Lo". 7 AUDIOLINE TAM828 OTHER TO RESET THE UNIT If unsuccessful in rectifying any of the above or an unusual symptom occurs, the unit can be reset as follows: # Unplug the power adaptor and telephone line from the power outlet and wall socket. # Plug the adaptor back into power socket. # If necessary replace the back-up battery. [. . . ] # Do not use abrasives, solvents or spray polish that may enter through holes in the cabinet and cause damage. # Do not place the telephone answering machine in direct sunlight or use in extreme humidity. 8 OTHER AUDIOLINE TAM828 GUARANTEE If you believe your TAM828 is malfunctioning, please refer to the relevant section and/or consult the troubleshooting guide in this manual to ensure that you have followed the instructions carefully. The TAM828 is guaranteed for a period of 12 months from the date of purchase. In the unlikely event of a fault during this period, please contact us for assistance. [. . . ]