User manual AUDIOLINE TEL 48 EXTRA PLUS

[. . . ] The unit must not be installed in damp rooms such as a bathroom or laundry room. Avoid proximity to sources of heat such as radiators and do not expose the unit to direct sunlight. We therefore recommend that this product should not be used on antique furniture, veneers or other wooden surfaces. connection Information: Connect the AUDIOLINE Telephone 48 Extra Plus to a TAE connection socket with F coding. [. . . ] Turn the b knob (beneath receiver) during the call. Warning: Setting the volume to its loudest volume may cause ear damage. Therefore, reset the volume to 0" after each call. 4 REDIAL If a connection that you have dialled is engaged or you were unable to get through to anybody, replace the receiver. The last number dialled remains stored in the telephone automatically. After dialling the telephone number, the current call duration in minutes and seconds will be shown in the display after a few seconds. You can also use the internal clock as a stopwatch. To do this, press the f button during a call or even with the receiver on the hook. The time measurement can be stopped using the same button f. the measured time will still be shown in the display for a few seconds. The display then jumps back to showing the present time. By means of the "KLINGEL" slide switch on the right-hand side of your telephone you can choose the settings "LEISE" (i), or "LAUT" to match the volume of the ringing tone to your requirements. If at any time you do not want to be disturbed, use the "AUS" setting. Use the sliding switch g on the right-hand side of the telephone to adjust the tone. Note: The tone adjustment function will not be affective when the reveiver volume has been set to minimum level. 8 STORING DIRECT AND SPEED DIAL NUMBERS You can store a telephone number for direct dialling on each of the buttons M1, M2 and M3 with your AUDIOLINE Telephone 48 Extra Plus. The direct dial button M3 is coloured red and is thus suitable for use as an emergency call button. An additional ten numbers can be stored as speed dial numbers. Now enter the required telephone number using the number pad. Now press the required direct dial button M1, M2 or M3 or a button on the number pad between 1 to 9 or 0 to save the telephone number as a speed dial number. Storage locations already used are automatically overwritten when you store a new telephone number in this location. The numbers stored can be recorded on the index underneath the receiver. [. . . ] All rights to claims under the terms of guarantee in accordance with this agreement must be asserted exclusively with regard to your sales outlet. Two years after the purchase and transfer of our products, claims under the terms of guarantee can no longer be asserted. This device fulfils the requirements stipulated in the EU directive: 1999/5/EU directive on radio equipment and telecommunications terminal equipment and the mutual recognition of their conformity. Conformity with the above mentioned directive is confirmed by the CE symbol on the device. [. . . ]