User manual AUDIOLINE TEL2

[. . . ] # Finish the call by replacing the handset or pressing the hook switch (item 2 on diagram). LAST NUMBER REDIAL If the number you called is busy or if you want to call the previous number again, just press the [REDIAL] button (item 7 on the diagram). NOTE: Only manually dialled numbers can be redialled in this way. Direct memories can not be redialled by this method. VOLUME CONTROL With the Volume Controls (item 6 on diagram) [VOL ·] and [VOL ­] you can increase or decrease the earpiece volume. NOTE: For use in Australia the volume adjustment should not be set higher than step 2. Settings 3 to 6 may cause the equipment to be outside the Australian requirements. [. . . ] If you want to change a number, enter the new number and the old will be replaced. If you wish to insert a pause (3 seconds) into the dialling sequence, press the [REDIAL] button (item 7 on diagram). ADJUSTABLE RINGER This telephone has programmable ringer selection. You can select between three levels of three types of ring signal plus ringer off. P Lift the handset (ignore network tones) # Press [STORE/MUTE] button P Press [#] button P Select required ring signal by pressing buttons 0 - 9 as per table below. P Replace the handset, the ring signal is now selected Key/setting 1 2 3 4 5 6 (default setting) 7 8 9 0 Melody type Melody A Melody A Melody A Melody B Melody B Melody B Melody C Melody C Melody C Off * Ringer level Low Normal High Low Normal High Low Normal High - * If setting 0 is selected, the ring signal will be turned off until the handset is lifted again. After that, the ring signal reverts to the previous setting. RECALL The [RECALL] button can be used to access additional Network services and PBX functions. The Audioline TEL2 is pre-set to 100ms Time Break Recall for Australia and 600ms for New Zealand. TROUBLESHOOTING NO DIAL TONE Try the phone in a known good socket to establish whether the fault is with the phone or the line. PHONE DOES NOT RING Lift and replace the handset and reset the ringer to the previous setting. MEMORY NUMBERS NOT DIALLING CORRECTLY Repeat the memory storage procedure and retry. WARNING It is recommended that you disconnect your telephone during a thunderstorm as you can get a shock from your telephone (and other electrical appliances). We recommend you follow these simple precautions during a thunderstorm: # Do not use your telephone unless the call is urgent. # If you must use your telephone, make the call as brief as possible and keep clear of electrical equipment and metal fixtures. # Do not stand in bare feet on uncovered concrete floors. # Do not touch brick or concrete walls. NOTE: Do not install your telephone in damp or high humidity locations, such as a laundry or bathroom. If any damage is caused by such elements it is not covered by the manufacturers warranty. CLEANING The casing should be cleaned by wiping with a damp cloth. # Do not use abrasives, solvents or spray polish that may enter through holes in the earpiece and mouthpiece and cause damage. # Do not place the telephone in direct sunlight or use in extreme humidity. REN (RN for New Zealand) The REN (Ringer Equivalance Number) or RN is of significance only if you wish to connect more than 1 telephone to your telephone line. [. . . ] DORO is the trademark of DORO AB. Notes For Operation In New Zealand The grant of a Telepermit for any item of terminal equipment indicates only that Telecom has accepted that the item complies with the minimum conditions for connection to its network. It indicates no endorsement of the product by Telecom, nor does it provide any sort of warranty. Above all, it provides no assurance that any item will work correctly in all respects with another item of Telepermitted equipment o f a different make or model, nor does it imply that any product is compatible with all of Telecom's network services. [. . . ]