User manual AUDIOLINE TEL38CLIP

[. . . ] 32 Storing telephone numbers in the phone book . 35 Deleting individual numbers from the phone book. 37 Dialling a telephone number directly from the caller list . 37 Storing telephone numbers from the caller list in the phone book . [. . . ] The display can show a telephone number with a maximum of 16 digits. If the number dialled is longer than this, only the last 16 digits will be displayed. If you want to change during a call from the receiver to the handsfree facility, press the button and replace the receiver on the rest. You will hear the dialling tone from the in-built loudspeaker. The display can show a telephone number with a maximum of 16 digits. If the number dialled is longer than this, only the last 16 digits will be displayed. If the other party accepts the call, his voice will be heard over the in-built loudspeaker. When using the handsfree facility always speak loudly and clearly towards the telephone. The volume can be adjusted using the handsfree button. If you want to change from the handsfree facility to the receiver, simply lift the receiver. Calls can be accepted either by using the receiver or by using the handsfree facility. The call duration is shown in the display in minutes and seconds during a call. The indication starts after the number has been dialled. The call duration still remains showing in the display for a few seconds after the call has been ended. If you want to reset the display during a call, simply press the display will reset immediately to 00:00. If a connection that you have dialled is engaged or you were unable to get through to anybody, simply replace the receiver. The last number dialled with a maximum of 32 digits will be saved in the telephone automatically. The saved redial number will now be dialled. You can switch off the microphone during a call using the mute button, . It is thus possible to speak without the other party hearing you. The loudspeaker remains switched on and you can continue to hear the other party. To mute the microphone, press the mute button once while a call is being made. [. . . ] Entering the pause when dialling manually once between the code for the outside line and the Press the redial button actual telephone number. After an outside line has been obtained, you telephone will wait for 3 seconds before dialling the actual telephone number. Storing the pause with the number after the code for the outside line and before Simply press the redial button the actual telephone number when storing the number. When dialling from the phone book, a pause of three seconds will then be automatically inserted after the code for the outside line. [. . . ]