User manual AUDIOLINE TEL5CLIP

[. . . ] However, due the diverse types of paints and surfaces which come into question, it cannot be fully ruled out that the footpads will leave marks on the surface on which it is located. 3 Private branch exchanges The telephone can also be connected to a private branch exchange. Ask the dealer where your private branch exchange was purchased whether the telephone will function properly on the private branch exchange. There is no guarantee that the telephone will work on every private branch exchange. [. . . ] Note: If the batteries are fully discharged, the time and date must be re-entered. 1 Making a call Your telephone can be used like any conventional telephone. Lift the receiver and wait until you hear the dialling tone. The display can show a telephone number with a maximum of 14 digits. If the number dialled is longer than this, only the last 14 digits will be displayed. You can end the current call by using the disconnect button and you will immediately obtain a new dialling tone. 2 Receiving calls When a call comes through, you will hear the ringing tone. The call can now be accepted using the receiver. 3 Call Duration Display The call duration is shown in the display in minutes and seconds during a call. The indication starts after the number has been dialled. The call duration still remains showing in the display for a few seconds after the call has been ended. 4 Adjusting the receiver volume If the receiver volume is too quiet or too loud for you, you can change this to suit your requirements. You can adjust the volume from soft to loud using the VOL. 5 Redial facility If a connection that you have dialled is engaged or you were unable to get through to anybody, simply replace the receiver. The last number dialled remains stored in the telephone automatically. to use the redial facility , proceed as follows: Lift the receiver and press the redial button F. The stored redial number will now be dialled. 6 Adjusting the receiver volume By means of the slide switch on the right side of the telephone base you can choose the settings (loud) or (soft) to match the volume of the ringing tone to your requirements. If at any time you do not want to be disturbed, use the (off) setting. 7 Storing speed dial numbers Your telephone allows you to store 10 numbers for speed dialling. The numbers 0 to 9 on the number pad are used as memory locations. Press the required memory location between 0 and 9 on the number pad. [. . . ] After dialling the number for the outside line, the telephone waits 3 seconds before dialling the actual phone number. 1 Fault finding Remove all extra telephone equipment and connect only the telephone directly to the telephone socket. If the fault is still present, connect another telephone (if available) to the telephone socket. The results will show you whether the fault lies with the unit or with the telephone line. [. . . ]