User manual AUDIOTRONICS 154

[. . . ] 15 Technical Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 16 Warranty . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 17 Customer Support . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 17 Notes . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Warning and Caution statements. Contact Sony questions. Electronics with any Do not install on a structure that is prone to vibration, movement or chance of impact. Failure to do so could result in damage to the display and/or damage to the mounting surface. Do not install near heater, fireplace, direct sunlight, air conditioning or any other source of direct heat energy. Failure to do so may result in damage to the display and could increase the risk of fire. At least two qualified people should perform the installation procedure. Injury and/or damage can result from dropping or mishandling the plasma display. Recommended mounting surfaces: wooden studs and solid-flat concrete. If the mount is to be installed on any surface other than wooden studs, use suitable hardware (which is commercially available). Page 4 Installation Manual SFM1 Parts List NOTE: This wall mount is shipped with all proper installation hardware and components. Make sure that none of these parts are missing and/or damaged before beginning installation. If there are parts missing and/or damaged, please stop the installation and contact Sony Electronics (800)222-7669. Wall Plate (1ea) Mounting Brackets (Left and Right) GriplatesTM (4ea) 5/16" x 3" Lag Bolts (4ea) (Wooden studs only) 5/16" Flat Washers-Metal (8ea) M6 x 12mm (4ea) Flat Panel List AUDIOTRONICS Fits All Sony Professional plasma and Large LCD Panels. Installation Tools Phillips Head Screw Driver Soft Material/ Blanket Portable Drill Pencil ¼" Drill Bit Tape Measure Level Wrench with ½" Drive Socket Installation Manual Page 5 SFM1 Flat Panel Mount Location WARNING: INVERT THE FLAT PANEL PLACE IT ON A SOFT, FLAT SUFRACE TO PREVENT DAMAGE TO THE FLAT PANEL. FAILURE TO DO SO WILL RESULT IN DAMAGING THE FLAT PANEL. GriplateTM Attachment Installation Manual Page 9 SFM1 Wood Stud Location 1. Using a stud finder, locate the 16" or 24" stud centers behind the wall. Once found, make a pencil mark on the center of the wood studs (Figure 9). NOTE: The wall plates have three 16" and 12" mounting slot positions. Stud Finder Wooden Studs 16" Wooden Studs behind the Wall Structure Figure 9. Measure from the floor to the desired viewing height and mark the wall (Figure 10). NOTE: This marking will reference the center of your flat panel display once mounted to the wall. 16" Measure and Mark the Desired Viewing Height on the Wall Figure 130. Measuring the Height Page 10 Installation Manual SFM1 Marking the Mounting Points 1. Place the bottom portion of the wall plate to the reference line and mark the four (4) lag bolt mounting points through the wall plate slots on the wall. Level the wall plate with the reference arrow pointing up to the ceiling (Figure 11). Wall Plate 16" Mounting Slots Level Wood Studs Figure 11. Marking the Mounting Points Installation Manual Page 11 SFM1 3. Use the information below when mounting to the following surfaces (Figure 12): Wood Studs: Drill four (4) ¼" pilot holes to the marked wall. Concrete Wall: Drill four (4) 3/8" pilot holes to the marked wall Drill Gun Pilot Holes 16" Figure 12. [. . . ] NOTE: Use a minimum diameter of 5/16" x 2 ¼"" long wedge anchors. 5/16" x 2 ¼" Wedge Anchors (4ea) Wall Plate Figure 14. Concrete Installation nstallation Manual Page 13 SFM1 Securing the Flat Panel to the Wall Mount WARNING: 1. At least (2) qualified personnel are strongly recommended for installation of this product. Failure to do so could result in serious injury and possible damage to the flat panel. [. . . ]