User manual AUDIOVOX 1284550

[. . . ] CDC-825 10 - DISC CD CHANGER CDC-10R WIRELESS REMOTE CONTROL (OPTIONAL) OWNER'S MANUAL HINTS FOR CORRECT AND SAFE OPERATION The CDC-825 is designed to be operated only on 12 volt DC negative ground systems. The unit can not be used on 24 volt or positive ground systems. INTERRUPTIONS IN SOUND (Skipping) The sound from the unit may "skip" and be interrupted if the antivibration springs are not set correctly, if the changer is mounted in excess of a 15° angle, or when travelling on very rough road surfaces. If this should occur, check for errors made during installation or wait for the road surface to improve. TEMPERATURE The unit may not operate correctly in extremely hot or cold temperatures. It is equipped with a built-in thermal protection circuit which will stop operation of the unit when the temperature reaches the pre-set level. [. . . ] Turn on the changer by pressing the PLAY/PAUSE switch on the control unit. The LCD panel on the control unit will illuminate and play of disc #1 will begin. Adjust volume, balance, and tone to your taste by using the controls on the car stereo. When the last track on a disc has played, the unit will automatically advance to and begin play of the next disc. When the last track on disc #10 has been played, the unit will automatically return to disc #1 and begin play again. WIRED CONTROL UNIT 1 9 8 7m b bl REMOTE SENSOR SPS 4 56 32 1 LCD DISPLAY The LCD Display Panel will illuminate when the CD changer is operating. Different symbols will appear depending on the function and operation in use. Each display is explained in the applicable function explanation below. 2 PLAY / PAUSE ( / ) 2 Pressing this button turns on the CD changer, illuminates the LCD panel and begins play of disc #1 if a new CD magazine has been loaded into the changer. If a magazine was already in the changer, play will resume from the track on the disc previously in play. Play of the disc is shown by the indication and the rotating disc symbol on the LCD panel. Pressing the button again will temporarily stop play of the disc. The pause indication will be shown on the LCD panel and the disc symbol will stop rotating and flash instead. Press the button again to resume play of the disc. NOTE: If left in the PAUSE mode for 5 minutes, the unit will automatically shut off. 5 3 POWER OFF SWITCH (OFF) Press this switch to turn the CD changer off and return to normal FM reception. activating the Scan 9 or Repeat 8 functions. 4 DISC SELECT ( - +) Press this disc select button to select the desired disc for play as shown on the LCD panel. The unit will automatically load the selected disc and begin play. To advance to a higher number disc, press the + side of the button. To return to a lower number, press the - side. 5 TRACK SKIP ( 6 TRACK SEARCH ( When the Shuffle button is pressed and held longer than 2 seconds, the "SHFL" and "DISC" indications will appear on the LCD panel and the discs in the magazine will be played in a random shuffled order, as well as the tracks on each disc. When all the tracks on the selected disc have been played, the next disc will be selected in shuffled order and its tracks will be played in shuffled order. The Disc Shuffle mode can be cancelled or by pressing the Shuffle button again, or by activating the Scan functions. Repeat ) The track skip function is used to quickly access the beginning of a ) or Backward Track particular track. Press Forward Track Skip ( Skip ( ) to locate the desired track as shown by the track number indication on the LCD panel. 8 TRACK / DISC REPEAT (RPT) When the Repeat button is pressed, the indication "RPT" will appear on the LCD panel and play of the selected track will be continuously repeated until the Track Repeat mode is cancelled by pressing the Repeat button or Shuffle functions. again or by activating the Scan 8 9 9 7 ) High-speed audible search to any section of the disc can be made by the button to advance quickly in search functions. Press and hold the the forward direction or press and hold the button to advance rapidly in the backward direction. [. . . ] Please perform the checks described below before contacting your dealer or service facility. Symptom No power Possible Cause Blown fuse Remedy Check fuses in vehicle fuse box and changer system. Replace as necessary with fuse of same type and rating as original. If fuse blows again, consult with service facility. Check all wiring and correct as necessary. [. . . ]