User manual AUDIOVOX 1285492

[. . . ] If you have the optional door lock/unlock circuit installed, the doors will lock. ARMING THE SYSTEM - PASSIVE (AUTOMATIC) If the passive arming feature has been selected: Turn the engine off, exit the vehicle, and close all doors. The dash mounted LED will immediately begin to flash rapidly indicating that the 30 second passive arming timer has begun. If the LED does not begin to flash rapidly, then you have left a door, hood, or trunk ajar. [. . . ] If the siren did not sound upon disarm, then the chirps have been turned off. Refer to the section titled ELIMINATING THE ARM/DISARM CHIRPS. As you approach the vehicle, press and hold the left button of your key chain transmitter for two seconds, or until the system responds. The parking lights will flash twice, and the dash mounted LED will turn off, confirming that the system is disarmed. If you have the optional door lock/unlock circuit installed, the doors will unlock. Note: If the passive arming mode was selected at time of installation, the dash mounted LED will start flashing rapidly indicating that the system is rearming. Opening any door will suspend the automatic arming. If the parking lights flashed three times, and the siren chirps four times, this indicates that the alarm system had been triggered in your absence. VALET/PROGRAM/MANUAL OVERRIDE SWITCH The valet switch allows you to temporarily prevent the APS-20 from arming, eliminating the need to hand your keychain transmitter to parking attendants or garage mechanics. When the system is in the valet mode, all alarm functions are by-passed, however the remote panic feature, and the optional remote door lock/unlock will remain operational. Start with the valet switch in the "off" position 2. Turn the ignition switch to the "on" position. Within 10 seconds of step 2, flip the valet switch to the "on" position. Page 3 VALET/PROGRAM/MANUAL OVERRIDE SWITCH (continued) The dash mounted LED will turn on solid indicating that the valet mode has successfully been entered. To return to the normal, (alarm mode), operation, move the valet switch to the "off" position any time the ignition switch is in the on position. Note: In the event that you lose your keychain transmitter or the transmitter fails to operate the alarm system, the valet switch can be used to disarm the alarm. This is referred to as the "Manual Override". Open the door with the vehicle door key. Turn the ignition switch to the "on" position. Flip the valet/override switch to the "on" position. The system will disarm and the siren will stop sounding, allowing the engine to be started, and the vehicle to be operated normally. Always remember to move the valet switch back to the "off" position to allow the passive arming and optional starter interrupt features to be operable the next time you park the vehicle. INTRUSION WARNING SIGNAL This system will inform you if an intrusion attempt has occurred while you were away from the vehicle. [. . . ] These features are separate, so the APS-20 may be programmed for one, or both, or neither. These features can only be used if the optional door lock/unlock circuit is installed. When the ignition door locking feature is programmed, the APS-20 system will cause all door locks to lock whenever the ignition switch is turned from the "off" to "on" position, (providing that all doors are closed at that time). All doors will lock approximately 2 seconds after the vehicle's ignition switch is turned on. [. . . ]