User manual AUDIOVOX 1285883

[. . . ] Model APS-785 Owner's Manual 4 Button Remote Start Security System With Plug-In Shock Sensor & Starter Disable FEATURES: w 2 Four Button Programmable RF Transmitters w Four Channel Code Learning Receiver (capable of accepting 4 transmitters) w Anti Code Grabbing Technology w Selectable Manual Override Mode w Remote Panic in all modes w Protected Valet/Override w Remote Start Safety Control Switch w Selectable Automatic Timed Start Mode w User Programmable Manual Override Code w 7 Function LED - Arm / Disarm / Zone 1 / Zone 2 / Zone 3 / Valet / Arming w Intrusion Alert with Memory w Audible Arm / Disarm / Defective Zone / Tamper Confirmation w Instant Siren Activation All Entry Points w Starter Disable When Armed w True Last Door Arming w Defective Zone By-Pass w Active or Passive Arming Selectable w Programmable Auto Lock On / Off w Programmable Auto Unlock / Off/Drivers Door/All Doors w Programmable Door Lock Pulse Duration 1 Second / 3. 5 Seconds/1 Sec L/ Dbl. U/L w Programmable Active or Passive Door Locks w User Programmable Permanent Chirp Delete w On Command RF Chirp Delete from Transmitter Or Selectable Through Software w 6 Tone Multi Tone Siren w Car Horn Activation for additional alarm response w Additional Negative Trigger Input w RF Inhibit with ignition on w Parking Light Flasher w Remote Keyless Entry With Optional Access Guard (must have power door locks) w Illuminated Entry w Plug In Dual Stage Shock Sensor w Remote Trunk Release (must have electronic trunk release) w Multiple Vehicle Capable w Remote Power Window Roll Up w Remote Garage Door Interface w Multiple Vehicle Capable OPTIONS : CAUTION !Be certain that the vehicle is outdoors before using this or any remote vehicle starting device. A running engine produces dangerous carbon monoxide fumes which can be harmful or fatal if prolonged exposure occurs. [. . . ] VALET SWITCH: The valet switch allows you to temporarily bypass all alarm functions, eliminating the need to hand your transmitter to parking attendants or garage mechanics. When the system is in valet mode, all alarm functions are bypassed, however the remote panic feature and remote door locks will remain operational. To use the valet mode, the system must first be disarmed either by using your keychain transmitter, or by activating your personalized manual override code. Page 4 1. Enter the vehicle, and turn the ignition key to the on position. Press and hold the valet pushbutton switch until the dash mounted LED turns on solid. The system will remain in the valet mode. To return to normal operation, press and release the pushbutton switch any time the ignition is on. NOTE : Always remember to return the vehicle to the valet off position. This will ensure that the vehicle remains protected at all times. The unit will report the new code three times with a one second pause between each code, then the system will begin arming. If the LED flash pattern reports the previously stored code, the new code was not entered correctly. Please repeat steps 1 through 7 above considering the following. NOTE: Acceptable digits 10ths or units are 1 through 9. The unit will not recognize a 0 (Zero), or no digit entered in any place, units or tenths. NOTE: If 15 seconds of inactivity expire, or if the ignition switch is turned off for more then 5 seconds during any of the above steps, the unit will revert back to the last successfully stored code. Page 5 Custom Code Programming Example: To Change the code from the factory pre-assigned code of 11 to "52" you would do the following: 1. Disarm the system by use of the transmitter, or by use of the emergency override sequence. Turn the ignition switch to the on position. Within 10 seconds, press and release the valet/override switch, 3 times. Within 10 seconds turn the ignition switch off, on, off, on, off, on. (The siren or horn will beep and the lights will flash one time. ) 5. Within 10 seconds, begin to press and release the push button switch to set the tenths digit. (As per the example, press and release 5 times to set the tenths digit to 5) 6. [. . . ] DO NOT remote start the vehicle if it is garaged. TO BEGIN THE AUTOMATIC START UP TIMER 1. Within 10 seconds, activate the RF start command two times. (Push the trunk/key button of your keychain transmitter 4 times). [. . . ]