User manual AUDIOVOX 1286147

[. . . ] Model APS-55LR Owner's Manual 3 Channel Remote Car Starter FEATURES : w 2 Three Button Programmable RF Transmitters w Three Channel Receiver (capable of accepting 4 transmitters) w Keyless Entry Outputs (+) and (-) w On-Board Start Relay w On-Board Accessory Relay w On-Board Ignition 1 Relay w On-Board Ignition 2 Relay w Ignition 2 Relay Selectable On or Off During Cranking w On-Board Parking Light Relay w Ignition 3 / Shock By-Pass / GM VAT Output (relay required) w Tach Signal Learning Circuit w Two ( + ) and Two ( - ) Safety Shutdown Circuits w Alarm By-Pass Output w Factory Disarm Output Before Start And During Unlock w Selectable Steady or Flashing Parking Lights for Run Indication w Selectable 5, 10, 15, 20 Minute Run Time w Selectable 1 Sec. , 3. 5 Sec. , or 1 Sec. /Dbl 1 Sec. Door Lock Output Pulse KEYLESS ENTRY 1. [. . . ] To access the car finder mode, while within range of your car, simply press and hold button 1 of your transmitter for three seconds. The parking lights will begin to flash making your vehicle more visible. The lights will stop automatically after 30 seconds. If you wish to turn off the car finder mode prior to the expiration of the 30 second timer, press and release button one of your transmitter one time . REMOTE STARTING THE VEHICLE The APS-55 will not start the vehicle if any one of the following situations exists; The vehicle's hood lid is opened. The safety control switch is in the Off position. To start the vehicle, press and release the button two times within 2 seconds. The vehicle will start and remain running for the pre-programmed 5, 10, 15, 20 minute run cycle. As a visual indication, the parking lights will flash or remain on depending on the setting by your installation center. When you arrive at the vehicle, turn the ignition key to the ON position (not the spring loaded start position), then step on the brake pedal to disengage the remote starter. [. . . ] SAFETY CONTROL SWITCH The red handle control switch allows you to temporarily disable the remote starting function of the system and moving this switch to the Off position is recommended whenever the vehicle is being serviced. When the system is disabled, the remote door locks and optional accessories will remain operational. FUNCTION SETTING CHART To be completed by installer Run Time Door Lock Timer Lights 5 Min o 1 Sec/1 Sec o Pulse o 10 Min o 3. 5 o Steady o 15 Min o 1 Sec/Dbl 1 Sec o 20 Min o © 2001 Audiovox Electronics Corp. , 150 Marcus Blvd. , Hauppauge, NY 11788 128-6147 [. . . ]