User manual AUDIOVOX 1286182A

[. . . ] The dash mounted LED will immediately begin to flash rapidly indicating that the 30 second passive arming timer has begun. If any entry point is opened during the 30 second arming cycle, arming will be suspended. When all entry points are closed, the arming cycle will begin again. At the end of the 30 seconds, the parking lights will flash once, the vehicle's horn (or optional siren) will chirp once, and the dash mounted LED will begin to flash slowly confirming the system is armed. [. . . ] Note: Two Step unlocking is an optional feature that must be wired upon installation. VALET / PROGRAM / MANUAL OVERRIDE SWITCH The valet switch allows you to temporarily prevent the system from arming, eliminating the need to hand your keychain transmitter to parking attendants or garage mechanics. When the system is in the valet mode, it will not passively arm or activate the starter interrupt circuit. However, all keyless entry features, as well as the remote panic feature will remain operational. Start with the valet switch in the "off" position 2. Turn the ignition switch to the "on" position. Flip the valet switch to the "on" position. The dash mounted LED will turn on solid (not flashing) indicating that the valet mode has successfully been entered. To return to the normal mode of operation, move the valet switch to the "off" position at any time the ignition switch is in the on position. Note: In the event that you lose your keychain transmitter or the transmitter fails to operate the keyless entry system, the valet switch can be used to override the optional Starter Interrupt, and therefore allow the engine to be started. Open the door with the vehicle's door key. Turn the ignition switch to the on position. Flip the valet/override switch to the on position. LED will turn on solid. Page 3 The system will disarm, allowing the engine to be started and the vehicle to be operated normally. Always remember to move the valet switch to the off position to allow the passive arming and optional starter interrupt features to be operable the next time you park the vehicle. ELIMINATING THE LOCK/UNLOCK CHIRPS You can selectively eliminate the normal lock and unlock chirps by holding the transmitter button slightly longer when locking and unlocking. This will prevent the horn/siren chirps for one lock or unlock cycle. If you find this inconvenient and wish to eliminate these chirps permanently, 1. Start with the valet switch in the off position. Turn the ignition switch "on" then "off". Within 10 seconds of turning off the ignition, flip the valet switch on, "off", "on", "off", "on", "off". If the chirps were on before you started, the siren will emit 2 short chirps indicating that the chirps are now off. [. . . ] All doors will lock approximately 3 seconds after the vehicle's ignition switch is turned on. This is a nice feature for maintaining the personal safety of the occupants of the vehicle, in an effortless and automatic manner. When the ignition door unlocking feature is programmed, the system will cause all door locks to unlock whenever the ignition switch is turned from the on to off position. All doors will unlock immediately after the vehicle's ignition switch is turned off. [. . . ]