User manual AUDIOVOX 1286474

[. . . ] If the opening is not large enough, carefully cut or file as necessary until the sleeve easily slides into the opening. Do not force the sleeve into the opening or cause it to bend or bow. Check that there will be sufficient space behind the dashboard for the radio chassis. Locate the series of bend tabs along the top, bottom, and sides of the mounting sleeve. [. . . ] The pointer will move along the dial to indicate the frequency to which you are tuned. This LED indicator within the AM/FM dial will illuminate red during reception of FM stereo broadcasts; if the stereo station is mistuned (not in the center of the frequency) this indicator may light intermittently or not at all. -7- 8 FM MONO/STEREO (MO. ST) BUTTON 9 LOCAL/DISTANT (LO. DX) BUTTON During FM radio reception, this button is used to select mono or stereo reception. Under normal reception conditions, the unit should be left in the stereo mode, as indicated by the FM Stereo indicator. If the stereo signal is too noisy for comfortable listening, press the MO. ST button to switch to mono reception. This button allows maximum reception in both weak and strong FM signal areas. For normal reception conditions, and when receiving a wide range of signals, including weak or distant stations, this function should be set to the Distant (DX) position, which will allow maximum signal reception. When in an extremely strong (local) signal area, select the Local (LO) setting. This will eliminate weak signals and suppress overly strong signals. When moving out of the strong signal area, switch to the Distant setting. NOTE: The Local/Distant button only affects FM signals, and will have no effect on AM signals. 6 MANUAL TUNING CONTROL 7 FM STEREO INDICATOR bl AM ANTENNA TRIMMER It is very important to adjust the Antenna Trimmer for optimum AM reception. The antenna trimmer is located on left rear corner of the chassis. Adjust this control after wiring connections are complete and before the radio is inserted into the dashboard opening. Proceed as follows: 1. Tune in a weak station around 1400 kHz on the AM band. 2. Using a small screwdriver, slowly adjust the trimmer for maximum output from the radio. NOTE: The Antenna Trimmer only affects AM reception, and will have no effect on FM reception. The Trimmer only needs to be adjusted when the radio is first installed and at any time a change is made to the vehicle antenna (replacing the mast, etc. ). bn FAST-FORWARD/EJECT (FF/EJ) BUTTON This button performs two functions. To eject a cassette, simply press the button fully then release. The cassette will eject and radio operation will resume. To fast-forward the tape, press the button half-way in to the locked position. To stop fast-forward and resume normal tape playback, press the button slightly and release. Do not press fully in or the cassette will be ejected. NOTE: Never leave a cassette engaged in the player when not in use. [. . . ] Output Impedance: Compatible with 4-8 ohm speakers Tuning Range: AM: 530 - 1710 kHz. , FM: 87. 7 - 107. 9 MHz. Sensitivity: AM: 100 uV; FM: 10 uV (for 30dB quieting). FM Stereo Separation: 30 dB Tape Frequency Response: 50-10, 000 Hz. IN NO CASE SHALL THE COMPANY BE LIABLE FOR ANY CONSEQUENTIAL OR INCIDENTAL DAMAGES FOR BREACH OF THIS OR ANY OTHER WARRANTY, EXPRESS OR IMPLIED, WHATSOEVER. [. . . ]