User manual AUDIOVOX 1286634

[. . . ] MANUAL OWNER'S MANUAL AND INSTALLATION GUIDE INSTALLA ALLATION AV-428 Auto Reverse AV-428 DETACHABLE FRONT PANEL AM/FM/MPX RADIO WITH AUTO-REVERSE CASSETTE PLAYER, CD CHANGER CONTROLS AND QUARTZ CLOCK Released 1-10-03. 128-6634 1 of 16 INSTALL ALLA INSTRUCT INSTALL AT ION INSTRUC T IONS INSTALLATION INSTRUCTIONS This unit is designed for installation in cars, trucks, and vans with an existing radio opening. In many cases, a special installation kit will be required to mount the radio to the dashboard. These kits are available at electronics supply stores and car stereo specialist shops. Always check the kit application before purchasing to make sure the kit works with your vehicle. [. . . ] NOTE: Observe cassette operation cautions in Care and Maintenance section of this manual. bs bt EQUALIZER (EQ) BUTTON The EQ button applies preset sound effects to the unit's audio output signal. The EQ button, when pressed, will activate one of the following operating modes ( CLASSICS, POP M, ROCK M, DSP OFF or FLAT). If the Equalizer function is active, as momentarily displayed on the panel, and the bass and/or treble level is set, the Equalizer function reverts to the the FLAT setting. On the other hand, if the Equalizer function is activated, the bass/treble setting(s) are ignored. Conversely, when the Equalizer function is not active, the unit returns to the user set bass and treble levels. STATION SCAN (SCN) BUTTON When this button is pressed during radio operation, each station in the current band will be scanned in the upward direction; each displayed station will flash for 5 seconds before moving on to the next station. If the local mode is active, only the stronger, nearby stations in the current band will be scanned. When the desired station appears, press the SCN button again to remain on that frequency. co cp FAST-FORWARD/REWIND BUTTONS These buttons cause the tape to move rapidly in the direction indicated by the arrows. For example, if button is pushed when the tape is moving from left the to right ( >>> on the display panel), the tape will fastbutton is pressed while the tape is forward. If the moving from right to left ( <<< on the display panel), the tape will rewind. To stop fast tape movement, lightly push the opposite button. If the tape is allowed to fast-forward or rewind all the way to the end, the tape will reverse and automatically resume play. PROGRAM SELECTOR To manually reverse tape direction and play the other side (program) of the cassette, lightly push both the Fastand ) at the same Forward and Rewind buttons ( time. The change of direction will be shown by the arrows on the display panel. EJECT BUTTON ( ) Tape playback is stopped and the cassette is ejected by pressing this button. Radio operation will automatically resume when the cassette is ejected. NOTE: Never leave a cassette engaged in the player when not in use. Doing so can cause damage to the cassette and/or mechanism of the unit. Always press the eject button and remove the cassette before removing the detachable front panel. bu LIQUID CRYSTAL DISPLAY PANEL The Liquid Crystal Display (LCD) panel displays the frequency, time and activated functions, including a combination audio level/disc indicator in the form of dual ) with circular bar graphs depicting the disc icons ( strength of the audio signal. In addition, the display also contains a receive signal indicator which depicts the relative strength of the incoming broadcast frequency. cq 8 MODE SELECTOR (MODE) During radio or tape play, press this button to select operation of the optional CD changer as shown by CDC, the disc number and the track number on the display panel. Refer to the CD Changer Controls section for specific operating instructions. 128-6634 8 of 16 cr cs If the button is pressed when no CD changer is connected to the unit, no CDC indications will appear on the display panel. The unit will then return to radio operation. To return to the tape operation (if a tape is loaded in the unit), press the button again. During tape play, press this button to change to radio operation without ejecting the tape. [. . . ] When the SHF button is pressed and held for more than 2 seconds, the disc shuffle mode is activated; DSF will appear on the display and the play of the discs in the magazine will be played in a random shuffled order. This mode is canceled in the same manner as before. dt / ) This button is used to quickly select the beginning of a particular track. With each momentary press of the Forward ), the next higher track number Track Select button ( will be selected as shown on the display panel. Similarly, with each momentary press of the Backward Track Select ), the next lower track number will be selected. [. . . ]