User manual AUDIOVOX 1286682

[. . . ] The assembly can be mounted using the double stick tape by peeling the protective backing and placing on a clean flat surface. For mounting on uneven surface or area's exposed to direct sunlight where heat may effect the double stick tape, the screw provided can be used to further secure the LED assembly. Starter Inhibit Relay: Mount the starter inhibit relay near the ignition switch harness under the dashboard. You will have to locate and cut the low current starter wire later in the installation. [. . . ] Also, any time the program mode is entered and any transmitter is activated, all other transmitters will be erased. During the program sequence, you must have all transmitters present to be programmed that you wish to operate and activated one at a time during the program sequence. Each transmitter activated will cause the siren to chirp, once for the first, twice for the second and three times for the third. If a fourth is attempted to be programmed, the first will be erased and the fourth will move the other two forward in the program. Arming The System: With the system disarmed, press the arm/disarm button once. The siren will chirp once, and the LED will begin to flash and the engine starter will be disabled. 5 seconds after the chirp, the system will be completely armed. During the armed mode, the unit can be triggered by shock/vibration, or a change in voltage such as the interior light turning on. Arming With The Two Stage Shock Sensor Bypassed: With the system disarmed, press the arm/disarm button once, the siren will chirp once. Within 5 seconds, press button 2 one time. The siren will emit one short chirp indicating the system is set and will be fully armed in 5 seconds with the shock sensor bypassed for one arming cycle. In this mode, the system cannot be triggered by the shock sensor. The only means of triggering is the voltage drop sensor. Arming With The Voltage Sensor Bypassed: With the system disarmed, press the arm/disarm button once, the siren will chirp once. Within 5 seconds, press button 2 two times. The siren will emit one long chirp indicating the system is set and will be fully armed in 5 seconds with the voltage sensor is bypassed. In this mode, the system cannot be triggered by a change in voltage. The only means of triggering is the shock sensor. In The Triggered Mode: When the system is armed, if the voltage drops, or a strong vibration is presented to the protected vehicle, the unit will trigger. If a lesser vibration is presented to the vehicle, the shock sensor will emit a few warn away chirps. When triggered, the siren will sound for 30 seconds then reset and continue to protect your vehicle. During the triggered mode, the unit can be reset by disarming with the transmitter or by use of the override method described later in this manual. [. . . ] If the vehicle has no after fan, or delayed lighting system, then the unit can be set for 1 chirp, trigger capable 8 seconds after arming. After your selection is made, press the arm/disarm button one time to lock in the setting. NOTE: If there is no transmitter activity during this mode for 20 seconds, the unit will exit the program mode and return to the disarmed mode. Emergency System Override: If in the event the transmitter becomes inoperative while the system is armed, a method of overriding the alarm is required to allow you to start the vehicle. To override the system without the keychain transmitter: a) Open the vehicle door, the alarm system will sound. [. . . ]