User manual AUDIOVOX 1287131

[. . . ] Model APS-596 Owner's Manual 4 Button Remote Security System with Dual Stage Shock Sensor IMPORTANT !In order to provide the highest possible level of security to your vehicle, this system is equipped with selectable manual override circuitry. It is possible that you will need to manually override your security system if the transmitter becomes lost, or inoperative due to battery failure. Reading the sections on "MANUALLY OVERRIDING YOUR SYSTEM" is necessary to fully understand the procedure required to enable your vehicle in such situations. [. . . ] Note: Always remember to return the system to the NON VALET mode, after servicing, to ensure that the vehicle remains protected at all times. 5 128-7131 5 of 16 MANUALLY OVERRIDING YOUR SYSTEM: USING THE VALET SWITCH MANUAL OVERRIDE Your Security System can be disarmed without the use of the keychain transmitter. Finish by turning the ignition switch to the off position. If the new code was accepted, the unit will report back the newly entered code, by flashing the LED, first indicating the 10ths digit, pause and then the units digit. The unit will report the new code three times with a one second pause between each code, then the system will begin arming. If the LED flash pattern reports the previously stored code, the new code was not entered correctly. Please repeat steps 1 through 7 above considering the following. Note: Acceptable digits 10ths or units are 1 through 9. The unit will not recognize a 0 (Zero), or no digit entered in any place, units or tenths. Note: If 15 seconds of inactivity expire, or if the ignition switch is turned off for more then 5 seconds during any of the above steps, the unit will revert back to the last successfully stored code. 6 128-7131 6 of 16 Custom Code Programming Example: To Change the code from the factory pre-assigned code of 11 to "52" you would do the following: 1. Disarm the system by use of the transmitter, or by use of the emergency override sequence. Turn the ignition switch to the on position. Within 10 seconds, press and release the valet/override switch, 3 times. Within 10 seconds turn the ignition switch off, on, off, on, off, on. (The siren or horn will beep and the lights will flash one time. ) 5. Within 10 seconds, begin to press and release the push button switch to set the tenths digit. (As per the example, press and release 5 times to set the tenths digit to 5) 6. Within 10 seconds of the last press of the pushbutton, turn the ignition switch off then on. Within 10 seconds, begin to press and release the push button switch to set the units digit. (As per the example, press and release 2 times to set the units digit to 2). Turn the ignition switch to the off position. Immediately observe the LED flash pattern. [. . . ] The battery should require replacement approximately every 6 months. If someone at the vehicle pages you by using the Valet/Push-Button Switch from within the vehicle, the Call Icon shown left will turn on and the hand held transmitter will beep or vibrate based on the units programming. Check Vehicle Status: Press the lock+key+option buttons simultaneously for 1 second. The vehicle's alarm will display the systems current status. [. . . ]