User manual AUDIOVOX AOM56WXSYS

[. . . ] AOM56WXSYS Wireless Observation System C amera C amera C amera C able P/N 37200038 6/5/07 Place transmitter on trailer at window level of the tow vehicle for best reception. Page 4 C amera C able Trans mitter M O N I T O R F E AT U R E S : C A M E R A F E AT U R E S : · 5. 6" high performance LCD monitor with12V accessory plug · Built-in speaker · Convenient front controls (power on/off, brightness adjust · Allows full time rear viewing while driving · Comes with suction cup monitor mount that allows monitor to be easily mounted to the windshield of any tow vehicle · Monitor can move from one tow vehicle to another · Monitor dimensions: 5-7/8"W x 5-1/4"H x 1-1/4"D · 12 Volt · Infrared LED illumination for enhanced low light performance · Mirror image · Locking waterproof cable connector for durability and long life · Non-corrosive mounting bracket Stainless steel hardware · Wide viewing angles · Camera dimensions: 2-11/16"W x 1-5/8"H x 21/2"D Trans mitter Monitor/R ec eiver Monitor/R ec eiver AOM56WXSYS PACKAGE INCLUDES: One 5. 6" Color LCD Monitor with 12V Accessory Plug, One Suction Cup Monitor Mount, One Rear Color Camera, One Cable for Trailer, Transmitter, Receiver, Stainless Steel Hardware, Non-Corrosive Mounting Bracket. 53200 Marina Drive · Elkhart, IN 46514 · www. asaelectronics. com Features and Specifcations Subject to Change Without Notice. Planning the Installation Before you begin, consider the following points: l of Sight: For optimum reception, place the transmitter so Line that it is level with the receiver/monitor in the tow vehicle, preferably at window level, allowing the signal to transmit through glass (see back page). [. . . ] The hole pattern on the back of the receiver/monitor is a standard cell phone mount pattern, allowing you many options. When choosing a mounting option other than the suction cup mount supplied in the AOM56WXSYS, choose a mounting device suitable to sustain the combined weight of the receiver/monitor. FIGURE 1 FIGURE 2 Installing the Transmitter (WLO24TX) 1. Choose an appropriate location for the transmitter. Drill a 1" hole to route the power and extension cables through. Run the camera extension cable from the camera to the transmitter. Run the power and ground from the power source to the transmitter. Attach the transmitter to a clean/dry surface using the 3M adhesive tape ring (supplied). Wiring the Transmitter and Camera CAMERA EXTENSION CABLE To 12 Volt (+) To Ground (­) Choosing a Transmission Channel The transmitter and receiver can operate on one of four different channels. The channel switches for the transmitter are located behind the rubber plug on the bottom outside of the transmitter. [. . . ] If that does not improve the performance, look for an interference source near the vehicle and turn it off, keeping in mind that the interference source could be another vehicle with the same observation system. Page 2 The transmitter channel and receiver channel must be set to the same channel (1-4) to operate. OFF ON 1 2 3 4 1 2 3 4 1 2 3 4 1 2 3 4 Channel #1 ON Channel #2 ON Channel #3 ON Channel #4 ON Page 3 [. . . ]