User manual AUDIOVOX AVT-1928

[. . . ] UDIOVOX PECIALIZED PPLICATIONS, L. L. C. INSTRUCTION MANUAL 19" COLOR TELEVISION AVT-1928 The serial number is located on the rear of the set. For future reference, please copy the number here. Serial No. _________________________________ CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. The exclamation point within an equilateral triangle is intended to alert the user to important operating and servicing instructions in the literature accompanying the appliance. [. . . ] Use the number buttons to tune to the channel 2. Press the ADD/ERA button on the remote control. The channel will turn from magenta to green to show it has been added. Chapter 3: Operating Your TV-11 Erasing a channel from memory 1. Press the ADD/ERA button on the remote control. The channel will turn from green to magenta to show it has been erased. Changing the TV's channel memory with the menus You can also use the menu system to add/erase channels from memory: 1. Use the number buttons to tune to the channel, then press MENU. Use the CH buttons to select SETUP and press VOL . Use the CH buttons to select EDIT PROGRAM. If the channel is in memory, it will be labeled "ADD", and the number in the corner will be green. If the channel is not in memory, it will be labeled "ERASE", and the number in the corner will be magenta. Use the VOL buttons to change the ADD or ERASE setting. Wait 7 seconds, or press MENU twice to exit. Displaying the Current Channel 1. To quickly see the current channel, press RECALL. The current channel will be displayed briefly. 12- Chapter 3: Operating Your TV Adjusting Video Settings You may wish to adjust the video settings (e. g. contrast or color) to obtain the most pleasing picture. This will allow you to manually adjust the video settings. 5. Use the CH buttons to select the video setting you wish to adjust. Descriptions of video settings are on the next page. Use the VOL buttons to adjust the video setting to the level you prefer. Use the CH buttons to select another video setting to adjust. When you are finished, press the MENU button twice to return to normal viewing. Chapter 3: Operating Your TV- 13 Returning to the factory settings If you would like to return to the original video settings, as they were calibrated at the factory, follow these steps: 1. Complete steps 1-3 in the "Adjusting Video Settings" section, on the previous page. [. . . ] The picture rolls, slants, shows lines, is grainy, has poor color or has ghosts. · Try another station, if the other station is OK, it may be a station problem. · Check that the antenna is connected, is in good working order, has no broken wires and is adjusted correctly. · See if anything is interfering with the antenna signal. [. . . ]